Get matched with top drywall pros in Pearblossom, CA

The easiest way to cut holes in drywall for electrical boxes is to use a spiral saw with a drywall router bit. Hang the drywall without cutting out a hole for the box, but make sure you measure and mark where the box is located on the wall. Once you screw in the drywall sheet, drill a small hole into the box void, insert the spiral saw bit, and move it around the edge of the box using the inside wall as a guide. You can also use an oscillating multi-tool with an electrical box cutout for fast, professional results.

Eco-friendly options reduce environmental impact and often improve indoor air quality.

The two most common drywall thicknesses for ceilings are 1/2-inch and 5/8-inch. For most standard residential applications, 1/2-inch drywall is sufficient and widely used. It provides adequate support and is lighter and easier to handle during installation compared to thicker sheets. However, 5/8-inch drywall is often used for specific cases where additional benefits are needed. It is heavier but provides superior sound dampening and fire resistance. You should consider using 5/8-inch drywall for ceilings in commercial buildings, between a garage and a living space, or above a finished basement to meet building codes or for enhanced soundproofing.

You can paint over plaster, but repair any damage to the plaster first, or the paint will crack and bubble. You should also prepare the surface of the plaster to accept paint, which gives your paint job the best chance of looking good and lasting a long time. Before applying the color you want, apply a coat or two of primer. Additionally, use latex paint, and choose a latex paint with a satin finish for areas with dampness, like bathrooms.