Get matched with top buffing and polishing pros in Mokelumne Hill, CA

Marble is high maintenance, like most other types of natural stone flooring. However, because it is naturally a more porous stone, there are a few added care instructions. You will need to clean it often to prevent dirt and grit from scratching the finish and surface, keep it dry, clean up spills immediately, and have it professionally sealed and refinished at least once a year to maintain the shine and water-tight surface. However, investing in maintenance is a smart move because marble floors are among the most beautiful and valuable types of flooring when properly cared for.

It depends on the material. Sandstone, slate, and granite can be slippery in wet weather. Applying a sealant to the stone can often stop it from absorbing moisture and may reduce the likelihood of slipping. If you're concerned about losing footing, a safer option might be bluestone or concrete.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

The best cleaning method to use for your project will depend on the specifics of that project. However, sandblasting does come with the risk of damaging the surface you’re trying to clean. One safer alternative to sandblasting is laser cleaning, which can remove many of the same contaminants with a lower risk of damage and a lower overall cost.