Best pool and spa technicians near Dinuba, CA

It’s easy to keep your hot tub clean and safe for all to enjoy by following a few simple tips:

• Make sure anyone who uses the hot tub rinses themselves and their swimsuits off, perhaps in an outdoor shower near the hot tub. 

• Don’t add anything to your hot tub’s water. Bath oils and bubble bath liquids might seem like a fun addition to your hot tub experience, but these substances will turn the water in your tub foamy and its surfaces hard to clean. 

• Restrict eating in the tub to light snacks that you can easily clean out if there’s any spillage. Crumbs from crackers and chips can be difficult to pick up. 

• Make it a no-pet zone. Pet fur and dander can pose a cleaning issue, but it’s also not a great idea for your pet’s health and safety. 

Generally, it is more cost-effective and energy-efficient to leave your hot tub on all the time rather than turning it on and off. Reheating a hot tub from a cold temperature consumes a significant amount of energy, so maintaining a constant temperature is usually more economical, especially with frequent use.

For daily or weekly use, it's recommended to keep the water at a constant, reduced temperature, such as between 80 and 95 degrees Fahrenheit, and then increase it to your desired temperature before getting in. If you know you won't be using the hot tub for an extended period, you can lower the temperature to save on energy costs. However, if you use it very infrequently, you can turn it off completely, as long as there is no risk of the water freezing.

To refill a hot tub after winter, start by opening up the tub and giving it a quick cleaning. If you use antifreeze, drain out the water then grab a hose and thoroughly clean the tub shell out, spraying water into each jet of the tub. 

Reconnect the hot tub and turn the power back on. When it’s time to fill the tub again, insert the hose into the filter well (if available). Avoid trapping too much air in the water lines, which can cause the pump to lock up when it starts again. Add the necessary chemicals and start the heating process. It will take some time—most of a full day—for the water to heat up again.

Most hot tubs will experience leaks due to wear and tear in the plumbing or the shell itself. The second most common issue is a heater malfunction due to the ongoing heat stress on moving parts. Finally, clogs happen in hot tub jets, especially when it’s time to change the filter.