Get matched with top pool and spa technicians in Laton, CA

It’s easy to keep your hot tub clean and safe for all to enjoy by following a few simple tips:

• Make sure anyone who uses the hot tub rinses themselves and their swimsuits off, perhaps in an outdoor shower near the hot tub. 

• Don’t add anything to your hot tub’s water. Bath oils and bubble bath liquids might seem like a fun addition to your hot tub experience, but these substances will turn the water in your tub foamy and its surfaces hard to clean. 

• Restrict eating in the tub to light snacks that you can easily clean out if there’s any spillage. Crumbs from crackers and chips can be difficult to pick up. 

• Make it a no-pet zone. Pet fur and dander can pose a cleaning issue, but it’s also not a great idea for your pet’s health and safety. 

Generally, it is more cost-effective and energy-efficient to leave your hot tub on all the time rather than turning it on and off. Reheating a hot tub from a cold temperature consumes a significant amount of energy, so maintaining a constant temperature is usually more economical, especially with frequent use.

For daily or weekly use, it's recommended to keep the water at a constant, reduced temperature, such as between 80 and 95 degrees Fahrenheit, and then increase it to your desired temperature before getting in. If you know you won't be using the hot tub for an extended period, you can lower the temperature to save on energy costs. However, if you use it very infrequently, you can turn it off completely, as long as there is no risk of the water freezing.

Most hot tub motors can last between five and 10 years; however, hot tub motors can burn out sooner if the hot tub water is not maintained or if the motors themselves are not maintained or protected from the elements. Since hot tub motors (also referred to as spa pumps) power the jets and circulate the water, they are important for the functioning of your spa. Buying a quality motor, keeping the hot tub filter clean, and keeping the wet end of the motor wet and the dry end dry can help them last longer.

Vinegar can be used as an all-purpose cleaner for many things, including hot tub filters. Soaking hot tub filters in vinegar and water for up to 24 hours can remove dirt and oil, and as a bonus, it won’t cause the water to foam after you reinstall it if there’s vinegar left on it. But make sure you still rinse it to remove any debris, dirt, or grime stuck on it.