Get matched with top welders in Banning, CA

Excellent. I called first for a free estimate, Someone came the next day and took photos. Next day, received a written estimate, much lower than the overpriced misguided 'other vendor.' Approved quote online and the next day, bright and early, the repairs were done. Benji replaced my bent,...

Fantastic.  Method Garage Doors and Gates personnel (project managers, welders, gate and fencing builders) were very professional in designing, fabricating, installing the wrought iron pedestrian gates, a vehicle sliding gate, and the gate operator track.  On the scheduled date of...

Weld new hinges on gate door as the originals had broken because they were improperly mounted in the first place.

I had a very pleasant auto repair experience with these guys. The muffler was literally falling off of my car. I looked on Angie's List and found the listing for Joe's Muffler. I pulled up to the garage and the mechanic waved me in. He gave me a really reasonable price which I accepted. He...

The guy who came out made a lot of mistakes and use poor (even dangerous) workmanship. After re-plumbing the hot water heater, he either didn't notice or tell me that I also had a gas leak in the gas line to my hot water heater! I noticed it two days later, on my own, after he was long gone. In...

The old downspout, that burst in heavy storms last winter, was custom made of welded metal. It had a welded, angular jog to get around a plumbing access opening in the wall. The new ABS downspout has a pre-fab rounded elbow at the top and a straight pipe to the ground. The cost of a new...

Luis is VERY punctual. For the estimate, he arrived an hour earlier than expected. The day of the job, I found him outside, an hour earlier, working on the car damage to the fence. Luis & his assistant worked quickly, fastening, welding, & painting.

Estimate was $6,750. I received several estimates from other companies, some lower, but this was just a job to them. Mitch was cheerful & creative. He could see that because of my disability, this job had to be done right. Both high & low power electrical circuits also had to be run. After...

ON THIS PARTICULAR VISIT MY EXPERIENCE WAS VERY GOOD, I HAD A LEAK IN MY EXHAUST, THEY LOCATED IT IN A PART OF MY EXHAUST THAT WAS NOT LEGALLY REQUIRED TO BE THERE, SO THEY CUT IT OUT AND WELDED IN A NEW SECTION OF PIPE, ALL WITHIN HALF AN HOUR.