Get matched with top plumbers in Auberry, CA

You don’t need to remove sediment from your water well. Sediment in your water well is normal. The problem is when the sediment enters your water supply. In this case, look into your pump. The size and placement of your pump can lead to sediment in your water. If it’s too big, it’ll overwork and stir up the sediment at the bottom, pulling it into the pump. If it’s too low, it will pull up the sediment that’s settled at the bottom. The Centers for Disease Control and Prevention (CDC) recommends annual well maintenance to check and test for cleanliness, mechanical problems, and contaminants.

Shut-off valves, like any other piece of metal hardware, can corrode, age, get worn down, and eventually break or rust into place. Occasionally spray your shut-off valve with WD-40 to stall it from rusting. If it really gets stuck, a wrench and WD-40 will usually do the trick, but you will need to call a plumber if it’s completely unmovable.

We highly recommend leaving the work of replacing drain pipes to a professional plumber. Drain pipes are a key part of your plumbing system, and making mistakes during the installation or even using the wrong size pipes for your specific fixture can lead to an elevated risk of leaks and clogs. Additionally, drain pipes prevent harmful sewer gas from entering your home, so hiring a professional plumber is essential to keeping the risk of leaks and clogs low and avoid reducing your indoor air quality.

No, a larger well pressure tank will not increase your home's water pressure by itself. Water pressure is determined by the pressure control switch on the well pump.

However, a larger tank does offer other benefits. It can store more water, which allows you to run water for longer periods before the pump needs to turn on. This reduces how often the pump cycles on and off, leading to less wear and tear on the pump and the entire well system. Consequently, a larger tank can help extend the life of your equipment and may prevent future pump issues that could affect water pressure.

If your goal is to increase water pressure, consider these alternatives:

• Adjust the pressure settings on your tank to a higher PSI (pounds per square inch).

• Replace your current pump with a model that has a higher flow rate, measured in gallons per minute (GPM).

• Have a professional install a water pressure booster pump in your plumbing system.

• If you experience pressure fluctuations, consider upgrading to a constant pressure system.