Get matched with top concrete resurfacing pros in Springerville, AZ

The biggest downside to resurfacing concrete is its lifespan. Concrete resurfacing lasts for five to ten years, on average, while a new concrete slab would last for 20 to 30. The cost of concrete resurfacing is much lower, but you get more value from full replacement. Resurfacing also doesn’t address any underlying issues with your slab, so you may need additional repairs, like mudjacking.

You can patch minor cracks and damage yourself using concrete fillers or mortar. Larger damage may require full replacement of affected slabs. However, water damage to your concrete will never disappear unless you address the root cause causing the water to cumulate. To prevent future damage, you can also waterproof your concrete.

Whether resurfacing concrete is worth the cost depends on the condition of the underlying slab. Resurfacing can be a good option if the concrete is in decent condition with only minor issues like standard wear and tear, small cracks, chips, or discoloration. In these cases, resurfacing adds a protective layer that can extend the concrete's lifespan without the high cost of a full replacement.

However, if the concrete has significant damage—such as deep cracks, peeling, sinking, or is broken up—resurfacing may not be worth it. The new overlay is only as good as the concrete beneath it, and existing problems like peeling and cracks are likely to show through the new surface. In situations with severe damage, replacing the entire slab is often more cost-effective in the long run and will yield a better result.

To make the best decision, it's recommended to have a licensed concrete specialist inspect the damage and determine if resurfacing is the right choice for your situation.

Mix the resurfacer into a sticky mixture. The consistency should look like mashed potatoes. Use a squeegee to push the resurfacer across the pitted area and smoothen the surface with a cement trowel flush. Make sure you protect any expansion joints with a weather strip. Alternatively, cut out any resurfacer that touched the joint once the mixture begins to harden.