Get matched with top pressure washers in Stephens, AR

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

We don’t recommend pressuring washing clapboard siding. At high levels of pressure, a pressure washer can damage wood siding permanently. Pressure washing can also make it easier to drive water into the cracks of clapboard (which are recommended for easier drainage), causing moisture damage.

If you think your clapboard siding is so dirty it could benefit from pressure washing, we suggest contacting a pressure wash cleaning service and getting a quote on a wood siding project. Some siding manufacturers recommend never pressure washing because it can force water behind the siding.

While some pressure washers, when used at lower settings, are ok to use on tires, we suggest proceeding with caution. While the high pressure alone won’t cause damage to your tires, pressure washers emit high-frequency pulsations that can damage the tires’ sidewall cords. Using a medium-bristle brush and soapy water is a better bet if you want to keep your tires in tip-top shape.

Before pressure washing, you can spray your deck lightly with a deck cleaning solution made of equal parts oxalic acid and water. Oxalic acid has a brightening effect that will lighten mold stains and return the deck to its original freshly-sawn look. Allow the solution to sit for about 20 minutes before pressure washing so it has time to take effect.