Get matched with top sink installation pros in Midway, AR

Try to tighten the clevis crew and adjust the lift rod if your sink stopper won’t stay up. Sometimes your screws became too loose over time, and as a result, there wasn’t enough resistance to keep the sink stopper up. If a damaged lift rod is the cause of the problem, you will need to replace it with a new rod.

The best place for a kitchen sink drain is the middle of the sink. Most people prefer center drains because they allow for better water and waste drainage, and the center location limits splashing because water flows straight down the drain hole. If the sink drain is too close to the edge of the sink, water can collect and drain too slowly. It can also be easier to clean sinks when the drain is closer to the center since debris is easier to wash down and doesn’t collect along the sides as easily.

Yes, a toilet, sink, and shower can share the same vent. This is a common installation method that can simplify plumbing and save space. However, there are important considerations. The vent and associated plumbing must be large enough to handle the demands of all fixtures without compromising the vent's effectiveness. Additionally, the toilet should always be located downstream of all other fixtures. Because requirements can vary and space might be limited, it is essential to check your local building and plumbing codes and consult with a qualified plumber to ensure the installation is done correctly.

Clean regularly with non-abrasive cleaners, avoid pouring grease down the drain, and check for leaks under the sink.