Best stone countertop pros near Eudora, AR

Yes, it is possible to cover old countertops with new ones. Using a countertop overlay to cover your existing countertop is a good way to get a totally new surface without removing your old countertops. This method can be more cost-effective and less time-consuming than a total replacement.

Both marble and quartz are decent kitchen countertop choices for different reasons. Marble provides an elegant look that’s sure to attract eyeballs, which can add value to a home. However, this isn’t the most durable material around and is easily scratched and stained. Quartz may not offer a classic look like marble, but it is available in a wide range of colors and patterns. It’s also durable, with the ability to resist scratches and stains.

Engineered stone is nonporous, unlike natural stone, and does not need to be sealed. You do not have to worry about etching or bacterial growth. It is more durable than natural stone and concrete, as well as highly heat resistant. Engineered stone is easy to clean and maintain. You can wipe it down with warm water and soap. Use a non-scratch scrub pad for stains and avoid any harsh cleaners. Engineered stone can even be eco-friendly, with some manufacturers using waste byproducts or organic resins.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.