Get matched with top woodworkers in Dierks, AR

Tipping contractors, builders, or general contractors is not customary or expected. Unlike many service professions where tipping is built into the payment structure, construction professionals typically charge a full rate for their services. However, you may choose to tip a worker for exceptional service, such as if they go above and beyond, stay late to meet a deadline, or work on a holiday weekend. Before offering a tip, it's a good idea to ask about the company's policy, as some prohibit their employees from accepting gratuities. If you want to show your appreciation for a job well done without giving a cash tip, consider writing a positive online review or offering to serve as a reference for potential new customers.

Most landscape timbers are 8 feet long, but some are also available in 10-foot and 12-foot lengths. Choose the length that will allow you to install landscape timbers using the least amount of cutting to fit. Shorter timbers will allow you to more easily create angles and shorter plant bed sides.

Yes, you can find ceiling joists using simple tools if a stud finder isn't available.

Using a hammer requires patience and a keen ear. Gently tap the ceiling in a grid pattern, listening for sound changes. A hollow sound indicates space between joists, while a solid, dull thud suggests a joist. Mark the location with a pencil and confirm by tapping from different angles.

Alternatively, you can use a nail, but this method will leave small holes. You'll feel increased resistance when the nail hits a joist. Mark the spot and repeat the process every 16 or 24 inches to map the joist locations. This method is considered less reliable than using a stud finder.

There are two ways you can cut trim for doorways: with a miter saw or a table saw. Mitered joints need a 45-degree angle. If you’re unfamiliar with a miter saw, you might want to consider buying extra trim pieces or choosing butted joints instead. One wrong cut, and you’ll need to power up the saw again with a new piece. 

Butted joints—also called shaker style—don’t need a 45-degree angle. Instead, your side pieces attach perpendicularly to the header trim and only require a straight cut.