Get matched with top woodworkers in Murfreesboro, AR

Board and batten is a type of wainscotting that uses wider boards that are placed vertically, and it has a much more rustic aesthetic than wainscotting. Common wainscotting styles are raised-panel, flat-panel, and beadboard. Wainscotting is more intricate and will typically use more elegant, subtle trims compared to the more farmhouse-inspired boards of board and batten styles.

Tipping contractors, builders, or general contractors is not customary or expected. Unlike many service professions where tipping is built into the payment structure, construction professionals typically charge a full rate for their services. However, you may choose to tip a worker for exceptional service, such as if they go above and beyond, stay late to meet a deadline, or work on a holiday weekend. Before offering a tip, it's a good idea to ask about the company's policy, as some prohibit their employees from accepting gratuities. If you want to show your appreciation for a job well done without giving a cash tip, consider writing a positive online review or offering to serve as a reference for potential new customers.

Yes, you can find ceiling joists using simple tools if a stud finder isn't available.

Using a hammer requires patience and a keen ear. Gently tap the ceiling in a grid pattern, listening for sound changes. A hollow sound indicates space between joists, while a solid, dull thud suggests a joist. Mark the location with a pencil and confirm by tapping from different angles.

Alternatively, you can use a nail, but this method will leave small holes. You'll feel increased resistance when the nail hits a joist. Mark the spot and repeat the process every 16 or 24 inches to map the joist locations. This method is considered less reliable than using a stud finder.

You should avoid drilling or cutting into load-bearing beams because removing material will weaken it and increase the risk of structural damage or even collapse. If you do need to drill into a load-bearing beam, speak with a structural engineer first to discuss where it’s safest to drill and the width and depth of the bit that’s safe to use.