Get matched with top sink installation pros in Dierks, AR

If your sink is on an exterior wall that isn’t insulated, or if pipes travel through a cabinet against an exterior wall that prevents heated air from circulating around the pipes, the pipes can freeze, causing them to burst. The best way to avoid leaking sinks is to insulate the pipes and open cabinets in the short term to warm the water line up and prevent freezing.

Basic replacements can be done DIY, but professional services ensure proper sealing, leak prevention, and plumbing adjustments.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Older faucet fixtures may have some corrosion, leaving them stuck. Try a few techniques to loosen the fixtures.

• Wrap the fixture with a towel and tap the base with a hammer.

• Use a putty knife to gently remove any caulk that may be holding the handle or fixture in place.

• Apply a few drops of penetrating oil around the base of the fixture or around the nuts.

• Purchase a faucet pulling tool to pop the fixture loose.