Get matched with top stucco pros in Alma, AR

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

Quikrete will set without mixing. The process of pouring dry concrete into your concrete form and then adding water is called dry pouring. While this method makes pouring concrete simpler and easier, it reduces its strength and durability. It can be a viable option for small, decorative concrete pavers for walkways or for setting fence posts, but it’s not ideal for pouring slabs that will bear any significant amount of weight.

When cleaning stucco siding, it is recommended to use a pressure washer with a psi (pounds per square inch) between 1,500 and 2,000. This range provides sufficient power to remove dirt and grime without causing damage to the stucco surface. It's important to avoid using excessive psi as it can chip or crack the stucco. 

Using a wider spray nozzle and keeping a safe distance of about seven to 10 feet from the siding helps ensure a gentle and effective cleaning process. Always follow the manufacturer's guidelines and adjust the psi accordingly based on the condition of your stucco and the specific requirements of your pressure washer.

A standard drill will work just fine if you’re drilling small holes, and only a few of them. But anything with a diameter larger than 3/8 inch is best done with a hammer drill, since it is stronger, faster, and also makes your drill bits last longer. While you don’t absolutely need a hammer drill for stucco, it is a worthy investment if you think you might drill more holes down the road.