Get matched with top roofers in Satsuma, AL

A roof's ability to handle snow depends on its strength and the snow's weight, as wet snow is much heavier than dry, fluffy snow. While designs in snowy regions often allow for 35 to 50 pounds per square foot, a general guideline is that a typical roof can withstand about four feet of fresh snow, two feet of packed snow, or just one inch of ice. Factors like the roof's age, slope, and support structure also affect its capacity; newer, sloped roofs generally hold more weight than older, flat ones. Ice and ice dams add significant, dangerous weight. Because capacity varies, it is best to contact a professional roofing contractor or the original builder to determine the maximum snow load for your specific home.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.

EPDM roofs have a few common problems, most of which can be resolved with regular maintenance. This type of roofing is laid down in sheets with seams, which can be a starting point for leaks. Proper installation and roof sealing can often avoid seam issues. 

The material is also susceptible to tears and punctures from falling branches or other sharp objects. There are black and white versions of EPDM, and the black version is more prone to fade and succumb to UV damage. Regular roof inspections can protect the costs of rubber roof installation and extend the life of your roof.

You’re going to need a permit for nearly every roof-raising project. This is a very important step, as the work you’re doing has serious safety considerations. Professionals are the ones to handle this type of work—including sourcing the permits—as they have the expertise required to perform the work safely. Insurance and warranty are usually voided if you do this work without a permit, and you may even be required to halt construction and tear it down as a penalty for working without a building permit.