Get matched with top bathtub restoration pros in Littleville, AL

When buying caulk, look for ones labeled for tub and tile. These have either acrylic latex or silicone compounds. This allows the caulk to stick to smooth surfaces and prevent mildew from forming. 

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

Most homeowners need to wait at least two days, sometimes three, to use their bathtub following the reglazing process. That’s the normal length of time it takes for epoxy resin to cure. There are quick-dry epoxy kits available that cure in 12 hours, though. To ensure that the epoxy dries properly, try to ventilate the bathroom as well as you can.

The difference between resurfacing and refinishing is that refinishing only works on solid surfaces that are in good condition, whereas resurfacing will restore a cracked or worn surface to its original, blemish-free state. Refinishing will leave you with a smooth and glossy surface you can’t get from resurfacing alone. If that’s the look you’re going for, contact a local concrete finishing contractor to achieve it.