Get matched with top pressure washers in Leroy, AL

Costs depend on fabric type, drape size, cleaning method, and whether additional services like pressing or deodorizing are included.

This answer is a bit tricky because experts say both. You should apply your cleaning solution from bottom to top, but rinse from top to bottom to avoid streaking. When it comes to multi-story houses, you’ll want to start at the top floor and work your way down, but follow the above instructions for each level as if it were an independent structure, rather than washing the whole house as one unit.

A pressure washer’s size or power is measured in pounds per square inch (PSI). The amount of pressure you need will depend on your project and the material you’re washing, but consumer pressure washers range from 500 to 2,400 PSI. Porous materials like brick and stucco should not be blasted with anything stronger than 1,000 PSI, while you can use a PSI of up to 2,400 to clean a vinyl fence.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.