Get matched with top electricians in Equality, AL

Yes, electricians must be licensed, certified, and in most cases, insured. Licensing requirements vary by state and local municipality, but most U.S. municipalities require electricians to hold an electrical contractor’s license. It's always a good practice to confirm requirements with your local municipality. Even if licensing is not required in your area, hiring a licensed and experienced electrician often leads to a better end result.

A license is a legal requirement to operate a business and is necessary for pulling project permits. Certifications, on the other hand, are typically voluntary and demonstrate a certain level of expertise. In some cases, a certified electrician may send an apprentice or journeyman to perform the work, but they must operate under a primary electrician who holds the proper license.

Before hiring, you should verify the electrician's license, insurance coverage, and any third-party certifications. You can use Angi’s contractor licensing search to confirm a pro's license status. Additionally, businesses with the “Angi Approved” badge on our platform meet strict criteria, including having the required state and local licenses, passing a background check, and maintaining a high average rating.

By nature, two-prong outlets aren't grounded—but the box they run to might be, which makes them safer. The safest way to test if an outlet is grounded is to purchase a circuit tester, which cost about $20 at home improvement stores. 

If you discover your outlet (or outlets) aren't grounded, know that this greatly increases your risk of personal injury and electrical fires. You may want to consider installing new three-prong ground fault circuit interrupter (GFCI) outlets. On average, the cost to install GFCI outlets is about $210 per outlet.

You should not attempt to disable a smoke alarm unless you’ve already activated a replacement unit. To stop a hardwired smoke alarm from beeping, reset the device or silence the alarm. If you’re removing a hardwired alarm, shut off the power, turn the unit counterclockwise to remove it from the ceiling, and disconnect the wiring.

Usually, your house panel is one of the key components that must be replaced when upgrading your amp service. In many cases, you will also need to upgrade your meter base as well as other electrical components.