Get matched with top dishwasher installation pros in Elberta, AL

Your dishwasher drains through a hose that attaches to the plumbing below your sink or snakes out the back of your machine. In most cases, you can access one side of the hose from below your sink, as it usually ties into the same drainline that your sink uses. Otherwise, you may need to pull the dishwasher out of the counter to access it.

To get rid of standing water in your dishwasher, first try activating the drain mechanism by pressing and holding the cancel button for at least three seconds. If that doesn’t work, you’ll need to do some troubleshooting to drain the standing water from the dishwasher. This will involve shutting off the power, then scooping out the water, cleaning the drain filter, and clearing the air gap. You’ll also want to run the garbage disposal and check the drain hose for clogs.

Only if the dishwasher isn’t made of stainless steel. The corrosive chemicals in bleach will stain stainless steel and can also cause further damage. To stay on the safe side, stick with an extra cycle of vinegar to banish any lingering odors.

There are some dishwasher care tips to extend its longevity and keep your dishes sparkling. Not overloading your dishwasher is key to letting water and soap move freely through the unit. Too much soap can stress your dishwasher unnecessarily, causing it to break down sooner. 

Cleaning your dishwasher is essential for its performance, so every three to six months, put two cups of white vinegar in a dishwasher-safe cup on the top rack and run a complete cycle. When done, place ¼ cup of baking soda inside and run a short cycle to eliminate any lingering odors.