Get matched with top well and pump technicians in Kemmerer, WY

Here are some signs of a bad well pump that a pro should look at: 

• If your well pump isn’t pumping water, you could have a leak or malfunctioning pump on your hands. 

• If your water pump runs nonstop, there might be a leak or problem with the pressure tank, which can cause the pump to fail. 

• Low water pressure can happen because of your pressure tank, low-water levels, or a wrong-sized pump. 

• Dirt or sediment in your water can be a problem with a powerful pump, damaged pump filter, or the pump’s location.

A leaking well pipe is quite different from if the well itself is leaking. To seal a leaking well, pour a cement mixture or bentonite into the space between the well casing and the borehole wall. The heavier cement collects at the bottom to form a solid seal, pushing lighter materials like mud and fluids up toward the surface. Professional well installation companies have the equipment to do this properly. 

There are a few signs you can look out for to determine if your well pump needs to be repaired or replaced, including the following:

• Your water pressure fluctuates.

• You lose water entirely on occasion.

• You notice the pump making unusual noises.

• Water sputters out of your fixtures.

• Your utility bills suddenly spike without explanation.

• You notice sediment or cloudiness in your water.

• You hear that the pump runs continuously.

If you notice any of these issues, call a professional well pump repair service to inspect it and determine whether you should repair or replace it.

Yes, a bigger well pump can increase water pressure—up to a point. If you currently have a well pump of 8 GPM, you might notice a pressure boost when you go up to 10 GPM. However, overshooting significantly (going up to 15 GPM for an 8 GPM home) can strain your well system and result in things like burst pipes that can decrease your water pressure and make for costly repairs.