Get matched with top affordable plumbers in Wayne, WV

A toilet flapper will remain open when the chain that it is connected to is too short. The chain should lift the flapper just enough to allow it to open the rest of the way on its own. The chain should have just about half an inch of slack.

A standard toilet flange should fit snugly into the outflow pipe and sit level with the subfloor. Installing a new one without first removing the old one will make it impossible to form a seal and keep the toilet bowl bolted securely in place. 

However, if you’re dealing with leakage or wobbling because you’ve installed a new type of bathroom tile (making the floor taller), you may be able to avoid fully replacing the flange by opting for a toilet flange extender. Extenders typically come in kits for easy DIY installation, fit over the existing flange, and bring the drain connection higher.

No, a larger well pressure tank will not increase your home's water pressure by itself. Water pressure is determined by the pressure control switch on the well pump.

However, a larger tank does offer other benefits. It can store more water, which allows you to run water for longer periods before the pump needs to turn on. This reduces how often the pump cycles on and off, leading to less wear and tear on the pump and the entire well system. Consequently, a larger tank can help extend the life of your equipment and may prevent future pump issues that could affect water pressure.

If your goal is to increase water pressure, consider these alternatives:

• Adjust the pressure settings on your tank to a higher PSI (pounds per square inch).

• Replace your current pump with a model that has a higher flow rate, measured in gallons per minute (GPM).

• Have a professional install a water pressure booster pump in your plumbing system.

• If you experience pressure fluctuations, consider upgrading to a constant pressure system.

You don’t need to remove sediment from your water well. Sediment in your water well is normal. The problem is when the sediment enters your water supply. In this case, look into your pump. The size and placement of your pump can lead to sediment in your water. If it’s too big, it’ll overwork and stir up the sediment at the bottom, pulling it into the pump. If it’s too low, it will pull up the sediment that’s settled at the bottom. The Centers for Disease Control and Prevention (CDC) recommends annual well maintenance to check and test for cleanliness, mechanical problems, and contaminants.