Top-rated stucco pros.

Get matched with top stucco pros in Romney, WV

Enter your zip and get matched with up to 5 pros

Need a pro for your stucco service project in Romney, WV?

Select your specific project to find the pro for you.

Find Stucco pros in Romney

Becerra Restoration
New to Angi
Traditional Stucco - Repair or Partially Replace

Serving Romney, WV and surrounding areas

In business since 2012

Free estimates

Emergency services offered

Becerra Restoration is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests, and make their concerns the basis of our business.

Stucco questions, answered by experts

Properly maintained stucco can enhance insulation, reducing energy loss.

Solid, unpainted stucco shouldn’t suffer damage from dots of glue used for this task. If the stucco is dirty, you may notice slight marks when you heat and peel the glue away, but these aren’t permanent.

However, not all stucco walls are solid stucco. Some are “faux” stucco with a foam backing. This kind of stucco veneer is more susceptible to damage, including damage from hot glue. We don’t suggest attaching anything to these kinds of stucco walls, so make sure you check the stucco type before starting this project.

Yes, you can screw directly into stucco. Only do so if the item you are installing is a permanent fixture. Drill a pilot hole into the stucco using a masonry or concrete bit, then drive in the screw with a power drill or screwdriver.

To maintain stucco, inspect it annually for cracks and clean the surface with a mild detergent. Seal any cracks promptly to prevent water infiltration, and reseal or repaint as needed to preserve its appearance.

You can use small bits that are up to 3/8 inch in diameter, or larger bits that are 1/2 inch or more in diameter. Make sure the bits you use are coated with carbide or diamond; this information is usually visible on the package. You can also use hole saw bits to drill into stucco.

The Romney, WV homeowners’ guide to stucco services

From average costs to expert advice, get all the answers you need to get your job done.