Top-rated floor polishers.

Get matched with top floor polishers in Pulaski, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Pulaski, WI?

Select your specific project to find the pro for you.

Find Floor polishers in Pulaski

Avatar for Bright Day Cleaning Services
Bright Day Cleaning Services
3.2(
16
)
Clean & Polish Flooring - For Business

Serving Pulaski, WI and surrounding areas

In business since 2013

Free estimates

Emergency services offered

"They did an amazing job, and worked very hard. They showed up an hour late...and for the deep clean service were there for 6.5 hours (didn't even get to the inside of our fridge, and I didn't have them change bed linens). However, they were very friendly and our house looked wonderful! I would recommend them and use their services again!"
Response time2 days
Response rate96%
Recommended by83%of homeowners
Showing 1-10 of 12
Floor Polishers questions, answered by experts

You can use dish soap mixed with warm water to clean just about any type of flooring, and while vinegar is a great addition to some floor cleaners, it’s not a good idea to use it on wood flooring or engineered wood flooring. Vinegar is very acidic, and it can gradually eat away at the protective finish on wood floors. If you’re cleaning laminate, tile, concrete, or vinyl floors, feel free to use vinegar and water in a 1-to-1 ratio with a few drops of dish soap. For wood floors, substitute the vinegar for olive oil.

Services typically take 2-4 hours, depending on the area size and floor material.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

The best way to clean vinyl floors is to vacuum or sweep away debris and then mop the floors using a mixture of warm water and dish soap or vinegar. You can also use store-bought cleaners if they’re marked safe for vinyl surfaces.

If your floor is still sticky after mopping, chances are you used too much or too little of the cleaning solution. Using too little won’t get all of the grime off, but using too much can leave its own residue. Refer to the cleaning solution’s instructions and dilute it as directed.

The Pulaski, WI homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.