Top-rated lighting pros.

Get matched with top lighting pros in Port Edwards, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your lighting service project in Port Edwards, WI?

Select your specific project to find the pro for you.

Find Lighting pros in Port Edwards

Avatar for Homemade Design
Homemade Design
3.7(
322
)
Designer - Interior Lighting Plan

Serving Port Edwards, WI and surrounding areas

In business since 2006

Credit card accepted

"It is a waste of money. The great majority of people are not going to find any value out of the service. If you need design consultation, you need a full service consultation. If you already have knowledge and experience, and you just need to get a few ideas, then you don't need to pay for that. You can just get a magazine or a book since you already have the knowledge of basic designs in your head or a little bit of experience. To have someone call you and give you information over the phone, you are not getting the personal service that you need. You may as well take the money $49 and apply it to something else like getting someone else to come out and give you the service that you need. Because, you are not getting much, you are not getting anything at all. They are going to have you do the work. After talking to them and I was talking to other home designers, I found out that that was a waste of time and waste of money. I gave them a C because they didn't fail at what they do but they don't offer any value for what they do. There's not much value to it. The cost was fair. They didn't do a terrible job and the cost isn't terrible, it was only $49. It just has a very low value. For responsiveness I gave them a B because they will answer your phone and answer your emails."
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Lighting questions, answered by experts

If half of a string of Christmas lights is out, it is likely because of a single burned-out, loose, or broken bulb within that section. Long strands of lights often contain more than one circuit, so when one bulb fails, it can cause the entire circuit (or half the strand) to go dark. To fix this, inspect the unlit section and test each bulb to ensure it is tight and functioning properly. Replacing the faulty bulb or repairing a damaged shunt will typically solve the problem.

Yes, animals can trigger motion-sensor lights. In fact, this is a reason why some homeowners install motion-sensor lights, to catch sneaky little critters looking through the rubbish for a midnight snack. There are sensitivities to animal detection though, so you may want to look for an option that avoids animal detection as much as possible.

To maintain your outdoor lighting and prevent major issues, you should regularly clean the fixtures, inspect the wiring and connections, and replace worn or burnt-out bulbs promptly. These simple steps ensure consistent operation and extend the life of your lighting system.

The five common types of landscape lighting are up-lighting, down-lighting, spotlights, built-in lighting, and pathway lighting.

  • Up-lighting casts light upwards from the ground, mostly for aesthetic purposes.

  • Down-lighting directs light onto the ground, lighting pathways, or outdoor space.

  • Spotlights cast direct, focused lighting in any direction.

  • Built-in lighting integrates lighting into an outdoor feature.

  • Pathway lighting illuminates walkways, increasing safety.

Testing tools, such as Christmas light testers, non-contact proximity electrical testers, and multimeters, all simplify the process of testing Christmas lights. However, without one or more of those tools, testing Christmas lights the old-fashioned way only works sometimes. Without testing tools, the simplest testing method is visual inspection, which may or may not yield positive results.

The Port Edwards, WI homeowners’ guide to lighting services

From average costs to expert advice, get all the answers you need to get your job done.