Get matched with top flooring contractors in Mount Calvary, WI

Laminate flooring takes about 24 to 48  hours to settle. Before this, planks are not completely acclimated to your home, and walking on them could cause shifting and permanent damage to the flooring. You should allow floorboards to acclimate for 48 to 72 hours before installing so that they can adjust to your home’s humidity and temperature levels, but they will continue to acclimate and settle after installation. For this reason, avoid placing any furniture in the room for 72 hours after installation.

Your floors will continue to settle for a few months after installation, becoming less bouncy as they rest.

There are a few different types of finishes to choose from for the final step of the project. 

Water-based polyurethane sealants emit fewer odors and fumes but dry quickly, which can pose a challenge when trying to get a smooth coat. Oil-based polyurethane sealants let out more odors and fumes into the air (it’s especially important to wear a respirator if you choose this type), but they take longer to dry, which can be more forgiving during the finishing step. 

Some may prefer wood oil to polyurethane because rather than creating a layer, it becomes part of the wood. Wood oil takes longer to dry, and is less resistant to wear and tear; however, it creates a natural-looking result by enhancing the grain of the wood. 

Most DIYers can learn how to remove carpet although it’s time and labor-intensive. However, if you have glued-down carpet and are concerned about damaging the substrate below, it's best to call a professional carpet remover. Also, removing glue-down carpet is more work than dealing with wall-to-wall carpet because you have to get rid of all traces of the adhesive from your subfloor to prepare it for a new installation.

Not all attic floors are created equal—size, layout, and square footage often vary. The amount of weight an attic floor can hold depends on several factors including the joist size and position, any structural supports or subfloors, and the original intent of the attic design. Without structural reinforcement, your floor might only be able to support about 10 pounds per square foot of floor load before collapsing.