Get matched with top floor cleaners and waxers in Mosinee, WI

Cleaning floors is a relatively easy DIY job, but paying for a professional cleaning service is worthwhile if you don’t have the time to dedicate to cleaning or if you have particularly dirty floors, deep-set stains, or wooden floors that you might damage during the cleaning process. A professional house cleaner will have the tools and experience necessary to remove dirt, pet hair, debris, and even stains and discoloration from your floors without damaging them. The service is also relatively affordable, making it a great investment if you don’t have the time or tools to do it yourself.

To properly maintain and care for hardwood floors without damaging the finish, establish a regular cleaning routine. Sweep with a broom or microfiber dust mop daily, or vacuum weekly, to remove dirt and debris that can scratch the surface; be sure to clean in tight corners and under furniture. For a deeper clean, use a damp mop with a cleaner specifically designed for hardwood floors, but avoid using harsh chemicals or excessive water, as this can damage the wood. You can further protect your floors by placing mats at entryways to catch dirt and moisture and putting felt pads under furniture legs to prevent scratches. For long-term care, refinish the floors as needed to keep them looking their best.

Professionals use various tools and cleaning solutions based on the type of floor they’re cleaning. They often use industrial steam cleaners to pull debris out of the carpet. For localized stains, they may use a commercial cleaner or a mixture of water, vinegar, and dish soap. For tile, they’ll typically use dish soap and hot water, plus a mixture of baking soda and hot water for the grout. For cleaning wood floors, they might use a low-heat steamer, a mop with an oil wood floor cleaner, or a mixture of hot water, vinegar, and lemon juice.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.