Top-rated ceiling fan pros.

Best ceiling fan pros near Fremont, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your ceiling fan service project in Fremont, WI?

Select your specific project to find the pro for you.

Top-Rated Ceiling fan pros in Fremont - Updated Nov 2026

Avatar for Brey Electric, LLC
Brey Electric, LLC
5.0(
6
)
Ceiling Fan - Install

Serving Fremont, WI and surrounding areas

Approved

In business since 2024

Warranties offered

Small jobs welcome

Welcome to Brey Electric, LLC! In business since 2024, we are a full service electrical company who takes great pride in the quality of our work and guarantees customer satisfaction. We specialize in all maintenance and repair for both residential and commercial properties, and no job is too big or too small. Serving Neenah and its surrounding areas, be sure to give us a call today!

Electrical Panel
Planned location for Plug
Panel with Interlock kit
Exterior with Plug
Response time1 day
1 neighbors recently requested a quote
Recommended by16%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Ceiling Fan - InstallCeiling Fan - Repair

Serving Fremont, WI and surrounding areas

In business since 1971

Credit card accepted

"The furnace took 4 days to get approved( not counting a Sunday) the others were quick but the water heater had to be ordered so without hot water for a week. One ceiling fan was easy but within a year their policy changed and They would not install the one I purchased and had to get a new one approved and then ordered online and took several weeks to get straightened out. Not sure who was at fault, AHS, installer or scheduling with renter. Fee is usually $75 per visit"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Ceiling Fans FAQs, answered by experts

Fan power is measured by CFM, or cubic feet per minute. For every 1,000 feet of square footage in your attic, you need a minimum of 700 CFM. Steeper roofs may need larger fans or about 840 CFM.  You can figure the size of attic fan you need by multiplying the square footage of your attic floor by 0.7. (multiply by 1.2 for a steep roof and 1.15 for a dark roof). That number is the CFM required for your fan to run efficiently.

Installing a ceiling fan where no wiring exists is a difficult and potentially dangerous job that should not be attempted as a DIY project. It is recommended to hire a certified electrician to build the necessary electrical infrastructure. In some areas, building codes require this work to be done by a professional to ensure safety and compliance. Due to the complexity, this type of installation is a significant job that could cost up to $2,000.

No, a ceiling fan doesn’t have to be wired to a switch, but it’s often more convenient. You can use the included pull chain if your ceiling isn’t too high or install a remote module later, as they are a cheap, easy-to-install option that’ll let you control both the fan and light fixture.

If you’re removing a ceiling fan without visible screws, start by locating the fan canopy—a round cover placed above the fan blades and motor. There should be a thin ring that can be turned counterclockwise to remove the canopy and reveal the screws. After unscrewing the fan, you can disconnect the wires and remove the entire fan from the mounting hardware. For safety, make sure the fan switch is turned off before you remove the canopy. It may be easier to remove the fan blades first, too.

A typical fan installation takes between two and six hours. The exact timeframe can be influenced by factors such as the home's structure, existing electrical characteristics, ease of attic access, and whether complex wiring or additional attic ventilation work is required.

The Fremont, WI homeowners’ guide to ceiling fan services

From average costs to expert advice, get all the answers you need to get your job done.