Top-rated stucco pros.

Get matched with top stucco pros in Egg Harbor, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your stucco service project in Egg Harbor, WI?

Select your specific project to find the pro for you.

Find Stucco pros in Egg Harbor

Hip & Ridge Construction
4.5(
6
)
Synthetic Stucco - Install or Completely ReplaceSynthetic Stucco - Install or Completely Replace- For BusinessSynthetic Stucco - Repair or Partially Replace- For Business+4 more

Serving Egg Harbor, WI and surrounding areas

In business since 2011

Free estimates

Credit card accepted

"The roofers were extremely professional and nice. They found that the previous roofers did not put flashing around the skylights. All of the wood around them was rotten. They had to take all six skylights out to replace the wood. They did it with minimal dust inside. They took the time to put extra ice and snow barriers around the skylights. They went above and beyond. I would recommend Brian and his crew to anyone. Todd from Hip and Ridge Construction is friendly, professional and honest."
Recommended by100%of homeowners
Stucco questions, answered by experts

Stucco will dry in two to three days, but you should wait one to two months to allow it to cure fully before you paint it. The curing process is slow, but leaving the material exposed to air and natural moisture will help it reach its maximum strength. If you live in a hot, arid climate, wait a month before painting. Wait two months before painting if you live in a more moderate or wet climate.

Cracks, discoloration, and moisture intrusion often indicate necessary repairs.

Homeowners insurance generally won’t cover stucco damage unless it’s caused by a covered event like a storm or fire. You’ll need to pay out of pocket for damage caused by age, wear and tear, lack of maintenance, or faulty installation. Consult your policy for the specifics of what stucco damage is covered and what isn’t.

Yes, you can screw directly into stucco. Only do so if the item you are installing is a permanent fixture. Drill a pilot hole into the stucco using a masonry or concrete bit, then drive in the screw with a power drill or screwdriver.

You can use small bits that are up to 3/8 inch in diameter, or larger bits that are 1/2 inch or more in diameter. Make sure the bits you use are coated with carbide or diamond; this information is usually visible on the package. You can also use hole saw bits to drill into stucco.

The Egg Harbor, WI homeowners’ guide to stucco services

From average costs to expert advice, get all the answers you need to get your job done.