Top-rated heating and air conditioning pros.

Get matched with top heating and air conditioning pros in Clayton, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your heating and air conditioning service project in Clayton, WI?

Select your specific project to find the pro for you.

Find Heating and air conditioning pros in Clayton

Bear Point LLC
New to Angi
Air Ducts & Vents - Clean

Serving Clayton, WI and surrounding areas

Approved

\nBear Point LLC specializes in land clearing, forestry mulching, brush removal, excavation, grading, and site preparation throughout Wisconsin. We take pride in providing reliable service, honest communication, and quality workmanship on every project. Whether you’re preparing a homesite, clearing trails, reclaiming overgrown property, or improving your land, we’re committed to delivering efficient, cost-effective solutions with a focus on safety and customer satisfaction.

Avatar for North Alabama Technical Services
North Alabama Technical Services
4.9(
124
)
Boiler or Radiator Heating System - Install or ReplaceBoiler or Radiator Heating System - Install or Replace - For BusinessBoiler or Radiator Heating System - Repair or Service+47 more

Serving Clayton, WI and surrounding areas

In business since 2010

Emergency services offered

Credit card accepted

"Jim with North Alabama Technical Services removed some items from my computer so that I could send emails and attend to items I needed to address that day. As planned, the next day he thoroughly cleaned my computer, he also made helpful suggestions while working on my computer. I would call him again if needed and I thought the fee was reasonable."
2014 Super Service Award Winner!
Additional Photos
Recommended by97%of homeowners
Avatar for The Comfort Company
The Comfort Company
5.0(
3
)
Central A/C - InstallCentral A/C - Service or RepairDuctless Mini-split A/C - Install or Replace+14 more

Serving Clayton, WI and surrounding areas

In business since 2016

Free estimates

Warranties offered

"Hired the Comfort Company to install a new propane high efficiency furnace, air source heat pump and take out my old nasty oil tank. Very satisfied and my wallet took a smaller hit than I thought it would! Highly recommend!"
Boiler Install
Before and After Furnace Install
Samsung Mini Split System
Ruud Heat Pump and Furnace
Ruud Heat Pump

+3

Response time3 days
Recommended by100%of homeowners
Showing 1-10 of 40
Heating and Air Conditioning questions, answered by experts

Yes, you can put an AC unit on the roof of your home or commercial building. For proper installation, you’ll need to ensure the roof surface is flat, it’s accessible for maintenance and cleaning, and an AC installation pro agreed that your home is a candidate for package units. Don’t forget to consider the climate in your area, as homes that experience frequent tropical storms or hurricanes may not benefit from this type of system.

Your AC might not cool after a power outage because of a tripped circuit breaker, blown fuse, or damage to the compressor or capacitor. If you notice your AC not working after a power outage, in most cases, the breaker has tripped or the system has built-in brownout and blackout protection. Reboot the AC by turning it off at the thermostat, resetting the circuit breaker, and waiting 30 minutes to turn the AC on again. 

Unfortunately, a freon leak will persist even when your AC unit is off. The freon in the AC unit is under pressure no matter the status of the system, so it will continue to drip through the leak even when you shut off the entire unit. It will continue to leak freon until it’s completely empty.

The size window AC you need depends on the BTU and the size of the room you’re cooling. For a room with 8-foot ceilings, look for about 20 BTU per square foot of the room. For example, a 12-by-12-foot room should have an air conditioner with 2,880 BTU. You can buy something slightly more powerful, but don’t overshoot the BTU for a small room, or you’ll waste energy and have higher bills.

To reduce AC startup power for a whole-house generator, install a soft start kit or hard start capacitor, which lowers the initial surge by gradually ramping up the compressor. Using a smart load manager can also help by staggering startup loads, preventing a system overload and future costly repairs.

The Clayton, WI homeowners’ guide to heating and air conditioning services

From average costs to expert advice, get all the answers you need to get your job done.