Top-rated deck maintenance specialists.

Get matched with top deck maintenance specialists in Clayton, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your deck maintenance project in Clayton, WI?

Select your specific project to find the pro for you.

Find Deck maintenance specialists in Clayton

Severson, Inc.
5.0(
1
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Clayton, WI and surrounding areas

In business since 2003

Free estimates

Warranties offered

"My professional window installers were prompt, courteous, friendly and most importantly knowledgeable. They were able to answer my concerns and questions before during and after installation. The rooms were left clean and orderly. The yard and carport where the windows were stored after delivery by Lowe's was spotless, the old windows, trash and debris were gone! Very impressed! When we signed the paperwork for an installer we didn't know we were getting an entire company with Severson, Inc. Thank You Denise Capps"
Looking Down to the Kitc
Kitchen from Living Room
View from Loft
Kitchen
Recommended by100%of homeowners
Showing 1-10 of 40
Deck Maintenance questions, answered by experts

Yes, deck pier blocks can be used as an alternative to traditional deck footings, especially for smaller or low-to-the-ground decks. Unlike poured concrete and buried post footings, deck blocks do not require digging or pouring. However, their use is dependent on local building codes. Some areas, particularly those prone to high winds, earthquakes, or hurricanes, may not permit the use of deck pier blocks. It is essential to consult your local building codes before choosing them for your deck project.

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

It is possible to build your own deck, but it’s typically better to leave the work to a decking professional. Decks can be exceptionally complicated, especially if you want a wrap-around or second-story deck, and you don’t want to risk making an expensive or dangerous mistake. It’s usually better to hire a decking pro who can pull permits and build a structurally sound deck that will last for decades and provide the maximum return on investment.

You can nail or screw composite decking, but 3-inch decking screws are the better fastener choice. Unlike nails, decking screws won’t back out of the composite material over time. There’s also little danger of splitting composite material when driving screws, so you don’t need to pre-drill holes unless otherwise recommended by your decking manufacturer.

Footings for ground-level decks need to be at least 12 inches deep, and some areas require them to be even deeper. A standard range for deck footings is anywhere from 12 to 48 inches. The minimum footing depth is determined by an area’s frost line and soil conditions. If you’re unsure how deep to install deck footings, check local building codes to find the minimum footing depth in your area. 

The Clayton, WI homeowners’ guide to deck maintenance services

From average costs to expert advice, get all the answers you need to get your job done.