Best chandelier installation pros near Bloomer, WI

You will likely need an electrical permit to install outdoor lighting, but it depends on where you live. Some municipalities don’t require a permit for electrical work, but you should call your building department or ask your outdoor lighting installer if a permit will be necessary. Your professional should pull the permits for you, if required, and close them out after the work is done. Either way, you will be responsible for the permit fee, which typically falls between $50 and $150.

The light that your ceiling light gives off will largely depend on the type of light bulb that’s installed in it. If you’re looking to brighten a dark room, LED bulbs are the way to go. LED bulbs will emit the most light while also using less energy than standard bulbs. They can last up to 50,000 hours and will need to be replaced much less often than standard bulbs.

Motion-sensor lights use one watt while on standby and five watts while turned on. They’re usually on for one hour over a 24-hour period, bringing the total wattage to about 28 watts per day. LED lights use around 6.5 to 8 watts while on. If you leave an LED light on all night, with night ranging from 10 to 14 hours, you’re looking at using 65 to 112 watts a night. You can minimally cut your wattage in half by switching to a motion-sensor light.

Yes! As a matter of fact, there are many sensors that add motion to existing outdoor lights. These motion sensors attach to pre-existing flood lights and other outdoor lights without any fussy and potentially dangerous electrical work. Additionally, some flood lights and related fixtures ship with motion sensors built-in.