Get matched with top woodworkers in Tekoa, WA

Floor joists provide support and stability to the flooring installed above them, whether it be hardwood, tile, or carpet. They’re essentially horizontal beams that hold up the subfloor and everything that lies on top of it. Floor joists also help evenly distribute weight across their structure so that it’s shared between walls, beams, and your foundation.

It is common for a contractor to ask for a down payment before starting a project, especially for jobs that require purchasing materials and equipment or hiring a crew. The deposit amount can range from 10% to 50% of the total job cost. While a request for up to 50% is not unusual, a contractor should not ask for more than that, and you should never pay for a project in full before the work has begun. To protect yourself, always discuss payment terms before starting and have a written contract that outlines the project timeline and expectations. Additionally, be sure to hire reputable contractors and check their licensing and insurance before the project begins.

If you don’t have a power saw with a blade where you can adjust the angle, you could use a miter box and hand saw to make the cuts. The miter box contains wide slots to support the piece of baseboard and other narrow slots to accommodate the blade of the hand saw. However, it’s tough to make non-standard cuts beyond 30 or 45 degrees when using a miter box.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.