Top-rated asphalt driveway pros.

Best asphalt driveway pros near Weathersfield, VT

Enter your zip and get matched with up to 5 pros

Need a pro for your asphalt driveway service project in Weathersfield, VT?

Select your specific project to find the pro for you.

Top-Rated Asphalt driveway pros in Weathersfield - Updated Nov 2026

Avatar for Cornerstone Excavation LLC
Cornerstone Excavation LLC
5.0(
5
)
Gravel or Loose Fill Paving - Install, Spread or Scrape

Serving Weathersfield, VT and surrounding areas

Approved

In business since 2025

Free estimates

Credit card accepted

"Christian is great! Although he’s young, he’s motivated and wants to work. He was very great at communicating with us throughout the project as well. Excited to see how he continues to grow in this field!"
Response time4 hrs
2 neighbors recently requested a quote
Mr. Mom Property Maintenance
4.6(
26
)
Brick and Stone Driveways & Floors - InstallConcrete Driveways & Floors - Install- For BusinessConcrete Driveways - Install+3 more

Serving Weathersfield, VT and surrounding areas

In business since 2007

Free estimates

Emergency services offered

"


Mr. Mom helped us save costs by painting some of his leftover gutter materials so they would not clash with the rental house, and finished the job quickly so we could have it done before more rainstorms caused flooding in the basement.


"
Recommended by95%of homeowners
Showing 1-10 of 38
Asphalt Driveways FAQs, answered by experts

The dimensions of a driveway apron vary based on local building codes, the width of your driveway, and the distance between the driveway and the road. On average, aprons range from 12 to 24 feet wide and 8 to 18 feet long. Typically, the end of the apron connected to the driveway matches its width—such as 10 to 12 feet for a single-car driveway—while the end at the street flares out to allow cars to turn in and out more easily. In some areas, you may not be responsible for the portion of the apron that extends beyond the sidewalk, but this depends on local laws.

Chip seal layers gravel and a liquid bitumen one at a time on-site, while asphalt directly pours a pre-combined mixture. Asphalt must be sealed, but it will last up to four times as long as chip seal driveways. Aesthetically, chip seal has a natural, rustic look compared to the traditional asphalt slab.

Asphalt is made of aggregate materials (sand, rocks, and gravel) and bitumen, a viscous, petroleum-based, waterproof substance. These materials are mixed together at extremely high temperatures to form asphalt.

The answer to whether or not you need to get a permit before you start your driveway can vary widely based on local ordinances and the scope of your driveway ideas. In most urban and suburban areas, a permit is needed before building a new driveway to ensure that a homeowner is using safe materials and proper drainage practices while designing and constructing a new driveway. In some rural areas, a homeowner may not be required to apply for a permit. When building a new driveway on your own, always check with your local building department to see if you need to request a permit. When hiring a driveway contractor, verify that the right permits are being used before driveway construction begins.

Driveways should be sloped with a minimum 2% slope—anything lower will cause precipitation and runoff to collect. A 2% slope is the equivalent of a 2-foot rise over 100 feet. One quick way to check the integrity of your driveway’s slope: no more than four inches of water should collect on the surface longer than 15 minutes after rain.

The Weathersfield, VT homeowners’ guide to asphalt driveway services

From average costs to expert advice, get all the answers you need to get your job done.