Top-rated concrete resurfacing pros.

Get matched with top concrete resurfacing pros in Sheldon, VT

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete resurfacing project in Sheldon, VT?

Select your specific project to find the pro for you.

Find Concrete resurfacing pros in Sheldon

Avatar for Green Mountain Basement Solutions LLC
Green Mountain Basement Solutions LLC
4.0(
30
)
Concrete Flatwork - Repair & ResurfaceConcrete Flatwork - Repair & Resurface- For Business

Serving Sheldon, VT and surrounding areas

In business since 2007

Free estimates

Emergency services offered

"They were very good. They came by and did the work; I was very pleased with them. They were responsive and very detailed oriented. They cleaned up beautifully and they did exactly what they said they would. Their staff members were exactly what I expected. They were good, polite and nice to work with. I was very happy with them and I was happy enough to take a box of doughnuts down each morning to share with them. They were doing a good job and working extra hard under very difficult conditions. It was expensive because I wanted all the bells and whistles. I had a significant problem but their solution to the problem was far more comprehensive than anyone else that I got into to look at. They took it far more seriously and identified a basement wall that needed reinforcing. I was pleased with the entire proposal. I got lower quotes but did not feel that other people understood the problem as well. I got the value for money because I really don’t know how they could have done it for less when I saw what was involved."
Recommended by75%of homeowners
Showing 1-10 of 13
Concrete Resurfacing questions, answered by experts

Yes—as long as the area has been properly prepped. Different self-leveling brands and compounds have their own specific instructions for preparation; some may require that you add primer or grind the surface. Without proper preparation of the surface, the compound will not be able to fully bond to the concrete and fill the cure as a separate layer, which makes it prone to chipping.

Small cracks should be filled with a flexible crack filler, like a rubberized asphalt-emulsion crack filler or a flexible masonry crack filler. Larger cracks need something a bit more solid to prevent further movement and to avoid having to use too much of the flexible filler. For concrete, you can use a concrete backer rod while asphalt can handle sand, gravel, or even dirt.

Yes, you can grind concrete by hand, but it’s typically known as sanding concrete when done with a hand grinder. Additionally, you should only use this method if you’re working on a smaller area, like a countertop, rounding an edge, removing imperfections, or doing a spot repair versus a driveway or patio.

The easiest way to handle extra-wet cement is to pour it, let it harden, and then recycle it using one of the methods above. You can also crush it down and sell it for base materials, although this can be pretty time-consuming. Your best bet is to start with less concrete than you need and make more as you go to avoid this problem.

Concrete can crack from general wear, improper installation, or in response to uneven support from the soil underneath. Small, thin cracks on the surface of aging concrete are usually a result of normal wear and tear, while cracks on new concrete more likely indicate a problem with installation. Larger cracks or uneven steps can signify a much more severe issue. A concrete contractor should be able to diagnose the cause and repair concrete cracks for you.

The Sheldon, VT homeowners’ guide to concrete resurfacing

From average costs to expert advice, get all the answers you need to get your job done.