Get matched with top bathtub restoration pros in Parowan, UT

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

You can use other ways to seal the space where your tub and the bathroom tile meet. Using sealant tape, epoxy sealer, and spray foam can be just as effective as caulking your bathtub. When using alternatives to caulk, the one that is best for you depends on your preferences. 

Sealant tape takes less time and effort to use, which is why some homeowners prefer it. Meanwhile, epoxy sealer creates a smooth and glossy finish that can complement your bathroom. Lastly, spray foam is waterproof and can act as insulation for your tub.

Reglazing a bathtub can last as few as three years and up to 15 years. With proper application, the recoated surface is as durable as a brand-new tub. Clean your tub properly and avoid using abrasive cleaners to maintain the coating. If the weather conditions were cold or humid during resurfacing or the tub was significantly damaged, the reglazing may not last as long.

It takes about 24 hours for the tub resurfacing smell to go away or the total dry time, although you will notice it the most during the first couple of hours. Refer to the manufacturer’s instructions or ask your bathtub resurfacing pro how long it takes for the smell to dissipate.