"Brandon, Tg,were excellent.
They were on time, worked well together, let us give feedback, cleaned up as they went along, made sure we knew what was happening during each step.
I could not be happier, our shower was 30+ yrs. Pretty bad shape...
I am so excited to have a new shower, that I didn't have to wait 2 to 3 weeks for...
Cost was very affordable...
The person who came to our house from Bath fitter,was knowledgeable, and product I believe is made in the USA..
Our installers were wonderful...
They did such a wonderful job...
Thanks Bath Fitter
M B"
"I went with a local provider instead of Bath Fitter. I had received other recommendations others for Bath Fitters, that they had done good work, so they were one of our choices that we got a quote from, but I’m not going with them. The quote that they gave me, I believe was $2,500. They were prompt and they replied, things like that. Price was competitive, but the other one was better."
"Vortex Filtration Inc is a excellent company with vast experience & knowledge in conditioning potable well water. I recommend Vortex Filtration Inc to design build and install their patented Vortex water system to solved all well water conditioning issues. My client had a problem for over tens years prior to the installation of the Vortex system. Once installed, the well water in the holding tank was crystal clear. Thanks Vortex!"
"RSI is a great replumb company. The actual replumbing was outstanding and we opted for the upgraded pro-plex fittings to increase our warranty from 10 to 25 years (not an up sell by Jamey - our choice). They also put in-place a dedicated recirculation line for our tankless water heater. The RSI team (Kenny and Milo) was expert at locating and replacing the old polybutylene piping with minimal impact to sheetrock, tiles, and fittings. They finished the work early but were delayed in finalizing the project due to a delay from the Regional Building Inspectors, not RSI's fault. Our only suggestions are 1) better daily clean-up, 2) better attention to detail repainting sheetrock (we had to repeatedly point out areas for a 'redo' and adjacent areas for touch-up) - this seemed harder to do that we expected (this is why we gave them a B rather than an A for quality). Jamey was very responsive to us and answered our questions/concerns thoroughly and promptly. We will recommend RSI our neighbors and friends. "
EMCO Heating & Air is here for all your residential and commercial heating and air conditioning repair needs. As a full-service heating and air contractor serving St. George, Cedar City and the surrounding areas in Southern Utah, our team is highly specialized and can do anything from simple heating and air conditioning repairs to full HVAC designs and installs. Let our friendly HVAC technicians find the perfect heating and cooling solutions for you.
Applying drain cleaner is a common DIY solution to clogged drains, but it can be extremely harmful to your pipes and lead to corrosion and leaks. It is almost always better to try snaking a clog than using a drain cleaner, but the best solution is to hire a professional plumber. They can locate the clog and gauge the severity using a camera system and then decide if using a plumber’s snake, auger, or drain cleaner is the best option to remove the clog and limit damage to your plumbing system.
The best place for a kitchen sink drain is the middle of the sink. Most people prefer center drains because they allow for better water and waste drainage, and the center location limits splashing because water flows straight down the drain hole. If the sink drain is too close to the edge of the sink, water can collect and drain too slowly. It can also be easier to clean sinks when the drain is closer to the center since debris is easier to wash down and doesn’t collect along the sides as easily.
If you're replacing a similar model, you don’t always need a plumber to install a bathtub faucet since it will fit over the existing plumbing. That said, there is some room for error. If you’re uncomfortable with working on your plumbing, your installation is more complex than a simple replacement, or the piping is old and corroded, call a pro to handle the job.
If you notice water dripping from your bathroom fan, you likely have an accumulation of condensation. The fan pulls warm, wet air from your bathroom and into the attic. However, if the water accumulates as condensation over time, it can begin to drip back out of your bathroom fan. It’s important to take action quickly to prevent mold growth and water damage.
A couple of components work together to control your shower's water pressure. A water pressure regulator, located near your main water shut-off valve, will control the pressure as water enters your home. From there, your shower valve does the heavy lifting. Other factors that impact water pressure include the type of showerhead you install (rain showerheads tend to have lower water pressure than traditional wall-mounted showerheads) and whether the local building code requires a flow restrictor.
The Monument Valley, UT homeowners’ guide to affordable plumbing services
From average costs to expert advice, get all the answers you need to get your job done.
The water main line is essential to your home’s plumbing. Over time, it can develop wear or damage. Find out how much a main water line replacement costs here.
Hiring a professional for a plumbing repair or replacement? Learn why you should consider hiring a licensed plumber for the job, even if it’s more expensive.
Many homeowners are surprised to learn that there are different types of plumbers who handle different kinds of jobs. Learn about those differences here.
When you call the plumber to fix an issue you’ve been having, they may suggest an additional service or “upsell.” If you’re wondering whether these upsells are worth it, this guide breaks down the most common ones and how they might benefit you.