Get matched with top masons in Huntington, UT

You can hang holiday lights on brick without drilling by using hot glue, outdoor tape, or brick clips for your project. There are plenty of alternatives to consider, so consult a professional Christmas light installer to discuss the best options to preserve your brick exterior.

No, you shouldn’t lay bricks directly on dirt. While it might seem like a shortcut, it leads to a patio that shifts, sinks, and becomes a maintenance headache. Dirt expands, contracts, and erodes—none of which mix well with long-term stability. To build something that lasts, excavate the topsoil, compact a layer of crushed gravel, and add a coarse sand-setting bed. This layered base gives your bricks proper support, allows drainage, and helps block weeds from creeping through. Cutting corners here just means you’ll spend more time—and money—repairing your brick patio later.

The cost of masonry work varies widely depending on the type of masonry along with common cost factors like size, complexity, location, and season. Most exterior masonry work done in freezing temperatures tends to cost more because of the preparation and protection involved to keep the masonry from freezing before the mortar cures properly. The average price ranges per project or square foot for different types of masonry include:

• Brick wall (fence, garden wall, etc.): $10–$45 per square foot

• Natural stone wall: $40–$110 per square foot

• Manufactured stone veneer: $20–$40 per square foot

• Brick home exterior: $10–$30 per square foot

• Brick siding: $3–$10 per square foot

• Stone siding: $35–$50 per square foot

• Brick step replacement: $20–$30 per square foot

• Brick wall repair: $20–$40 per square foot

• Chimney repairs: $160–$750 per project

• Tuckpointing: $5–$25 per square foot

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.