Top-rated deck maintenance specialists.

Get matched with top deck maintenance specialists in Winters, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your deck maintenance project in Winters, TX?

Select your specific project to find the pro for you.

Find Deck maintenance specialists in Winters

Avatar for Pressurewashtx.Com
Pressurewashtx.Com
5.0(
6
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Winters, TX and surrounding areas

In business since 2011

Free estimates

Credit card accepted

"Great! They arrived at the time they promised. They were careful around my shrubs. The brick and siding of the house looked great and I was shocked at the difference having the driveway pressure washed made. I have asked them to contact me every 6 months to have it done again."
Additional Photos
Additional Photos
RV Cleaning
RV Cleaning
Additional Photos

+12

Recommended by100%of homeowners
E-Z Home and Lawn
5.0(
3
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Winters, TX and surrounding areas

In business since 2019

Free estimates

"Jim did an extensive remodel on a rent house for us. He gave good advice and was talented enough to handle all the projects including plumbing, electrical, ceiling fans, window install, door and jam replacement, new shower where used to be a tub, painting and texturing. Always responded to calls or texts and asked questions when something popped up we hadn t discussed. Worked hard and had some workers who were similarly diligent. It was a good experience for us and that isn t always the case with everyone you hire."
Kitchen update
Kitchen New home
Kitchen
Kitchen
Kitchen

+37

Response time2 days
Recommended by100%of homeowners
Showing 1-10 of 27
Deck Maintenance questions, answered by experts

Homeowners should build their floating decks at least 18 inches off the ground. Having it at this height will allow for better airflow underneath and help prevent moisture-related problems like warping or rot. That being said, local guidelines for deck heights may vary depending on where you live.

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

Ultimately, overapplication of stain can compromise the deck's appearance, durability, and longevity. It may result in an uneven finish, with excess stain pooling, dripping, or drying into thick patches. It can also obscure the wood's natural grain and texture, detracting from the desired aesthetic. Moreover, excessive staining may not fully penetrate the wood, leading to poor adhesion and premature wear. Additionally, thick layers of stain are prone to peeling, cracking, and blistering as they struggle to bond with the surface. 

In most cases, there should be a small gap between the house and the deck, usually no more than ½ to ¾ of an inch. This space allows water and moisture to flow through instead of pooling against the side of your house. It also lets flashing protect your siding from runoff, which is one of the most common issues with decks.

Spindles on a deck may also be called balusters or pickets. While not as important to the structural support of the deck as the rail posts, they play a critical role in ensuring the deck is safe to use by closing in large gaps in the railing. For this reason, balusters must be no more than 4 inches away from one another.

The Winters, TX homeowners’ guide to deck maintenance services

From average costs to expert advice, get all the answers you need to get your job done.