Get matched with top epoxy flooring pros in Snyder, TX

Spills like water, oil, or grease can wear down the epoxy's strength, lowering its lifespan. While this damage doesn’t happen immediately, it can accumulate over time, so cleaning up any garage spills as soon as they happen is essential. Avoid cleaning with or using dish soap on your epoxy floors since they will leave an unattractive residue. Instead, you can use half of a cup of ammonia diluted with a gallon of water for cleaning purposes.

Depending on the finish and area size, costs range from $3 to $10 per square foot. Decorative finishes increase costs.

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.

You can seal a concrete slab by cleaning the surface, filling in any cracks, etching the surface, applying a sealer, and letting it dry. Concrete slabs don't typically need sealing, but you can use a topical concrete sealer if you notice signs of water damage. If you haven't already fixed the cause of the leak, then you'll want to repair the plumbing before you seal a concrete slab.