Top-rated drywall insulation pros.

Best drywall insulation pros near Santa Fe, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Santa Fe, TX?

Select your specific project to find the pro for you.

TRUSTED BY SANTA FE, TX HOMEOWNERS

  • Average homeowner rating star icon4.5
    Average homeowner rating
  • Verified reviews icon597
    Verified drywall insulation services reviews

Top-Rated Drywall insulation pros in Santa Fe - Updated Nov 2026

Insulation Discounters
4.6(
1,035
)
Blown-In Insulation - Install or Upgrade

Serving Santa Fe, TX and surrounding areas

Approved

Super Service Award Winner

In business since 2008

Emergency services offered

Warranties offered

"This is a 1 man show, with a few contractors apparently but I only saw Ramy (?). We had an upstairs with hot rooms and my AC guy said we needed insulation, so I called this guy based on the reviews. He took a look and basically said the cheapest way to go was roof vents so we wouldn't have to demolish the ceilings (no attic, so the drywall would basically get all chopped up). I was a bit skeptical since this guy mentions Jesus every chance he can, but said why not as $800 seemed fair enough for 5 vents based on labor, since he did have to chop holes in my roof and seal up the vents later. He did all of it in around 3 hours the same week (plus maybe an hour later to put on more roof tar), always called ahead, and was on time. He didn't have a temperature probe to measure the work, but since he finished, the rooms are a lot cooler and my wife is happy. I found my temperature gun and it's definitely cooler. So given the AC doesn't work as hard and our upstairs stays cool, I'd say he knows what he's doing. I just ignored his constant references to Jesus and blessings and such as I don't hire contractors to spread their beliefs. The guy sounds like a used car salesman at times, but he does seem to know what he's doing, and he does follow up afterwards. So as far as contractors go that's pretty rare."
InsulSafe SP
Solar Vent
Attic Tent
Refridgerated Air Dryer
Radiant barrier

+135

Response time4 hrs
Response rate91%
36 neighbors recently requested a quote
Avatar for Take Air Duct & Carpet Cleaning Specialists LLC
Take Air Duct & Carpet Cleaning Specialists LLC
4.5(
78
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Santa Fe, TX and surrounding areas

Approved

In business since 2007

Free estimates

Emergency services offered

"Joe and Chris did an amazing job cleaning my totally blocked dryer vent. They were on time and worked great as a team. They took videos before and after the cleaning so I was able to see exactly how blocked my vent truly was. They also showed me evidence of a previous cleaning by another company, where they had not only not thoroughly cleaned the roof cap and vent pipe, but had dumped lint all over my attic instead of cleaning it up! They were also able to replace my dryer vent hose, which had collected water since the vent was blocked at the roof. Expensive? Yes - but beware the service you might get with another company's Groupon. You get what you pay for. My dryer runs better now than it did when it was brand new. I would hire these guys again in a minute. Excellent job!"
before
after
Additional Photos
Additional Photos
Additional Photos

+3

12 neighbors recently requested a quote
Recommended by84%of homeowners
Avatar for Hawx Insulation-Houston
Hawx Insulation-Houston
4.1(
361
)
Blown-In Insulation - Install or Upgrade

Serving Santa Fe, TX and surrounding areas

Approved

In business since 2013

Free estimates

Credit card accepted

At Hawx Pest Control, our company is based on the belief that our customers' needs are of the utmost importance. Our team is committed to meeting those needs. Hawx Premium Pest Control will treat your pests, mosquitos, and more- then keep them away for good. If pests come back between treatments so will we, at no additional cost to you. We welcome the opportunity to earn your trust and deliver you the best service. No job is too big or too small for our experienced team. Call today for a quote. \n

13 neighbors recently requested a quote
Recommended by75%of homeowners
Avatar for Clean Air Pro Services
Clean Air Pro Services
4.6(
53
)
Blown-In Insulation - Install or Upgrade

Serving Santa Fe, TX and surrounding areas

Approved

In business since 2010

Free estimates

Emergency services offered

"They did an excellent job. The before and after pictures really showed me what they did. They replaced the ducts that were damaged for less than what my a/c company was going to charge and replaced my insulation and did a lot more work as well. I am very pleased with them."
swamp went into the flue line down to the fire box
Bacteria Found in the plenum box
Attic space before
Cap was not properly covered or sealed.
Another angle of the plenum box with the Bacteria

+29

Response time11 hrs
Response rate100%
68 neighbors recently requested a quote
Avatar for FMI Construction Services, Inc.
FMI Construction Services, Inc.
4.9(
9
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Santa Fe, TX and surrounding areas

Approved

In business since 2005

Free estimates

Warranties offered

FMI Construction Services Inc. is a Houston, Texas-based construction firm with over 16 years of experience in the construction, consultation, management, and design sectors. Our expertise encompasses both residential and commercial projects, and we are committed to delivering high-quality workmanship on all engagements.\n\nWe encourage you to contact us to discuss your construction requirements.\n

Commercial
Bathroom addition
Shower upgrade
Complete Home Demo
Commercial

+374

Response time7 hrs
Recommended by100%of homeowners
Avatar for J & Andys Air Conditioning
J & Andys Air Conditioning
4.5(
1
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Santa Fe, TX and surrounding areas

Approved

In business since 2020

Free estimates

Credit card accepted

J & Andy Air Conditioning is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests, and make their concerns the basis of our business.

Response time5 hrs
Recommended by100%of homeowners
...
Showing 1-10 of 147
Drywall Insulation FAQs, answered by experts

Which style of corner bead you choose—whether metal or paper-faced—depends on your preference and if you’re comfortable using metal-cutting tools and a hammer. Metal bead offers superior strength and durability but its installation is slightly more involved. We’d say for most cases, it’s better to use metal bead but if you’re not comfortable working with metal, paper-faced bead will work just fine. 

How you hang the drywall can affect the finishing process. It's often easier to finish horizontal drywall panels, as the seams run across the wall rather than up and down. Standard drywall panels are 48 inches wide, so the seam is easy to reach without bending down or stretching your arms.

Vinegar and bleach are effective options for removing mold from drywall. Vinegar is a better choice if you have a smaller mold issue while bleach is best if you have a larger mold problem. If the area you're cleaning has limited ventilation, using vinegar would be a better option. In that case, you could mix vinegar with baking soda to remove more stubborn mold growth.

Depending on the place where the cutting error occurred, you may be able to fix it. Learning how to patch a hole in drywall is challenging, but if you can tape and mud drywall, you can do it. Having said that, patching is time consuming. Early in the installation process, you may find that it’s easier and far less time consuming to just start over with a new sheet of drywall, cutting a new hole in the right spot. You may be able to use part of the incorrectly cut piece elsewhere, so it’s not completely wasted.

Applying plaster to a wall will usually cost between $2 and $10 per square foot for both the material and labor. The cost will vary based on the quality of the plaster you’re using and whether or not prep work is required before the work begins. Wall prep can add up to about 10% to your total costs. Plastering exterior walls can be more expensive in many cases because they are taller and require scaffolding and safety equipment.

The Santa Fe, TX homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.