Get matched with top drain pipe installers in Gladewater, TX

If you've discovered a rather frightening buildup of brown and black gunk below your shower cover, you're not alone. The smelly sludge is often a collection of mildew and biofilm. Biofilm comes from the breakdown of soap scum, hair, skin cells, and bacteria that collects during shower time. It's quite common in a humid space and relatively easy to clean with a gentle DIY cleaning solution such as baking soda and vinegar.

The cost to unclog a drain varies based on the location and severity of the clog. For simple clogs within your home, such as in a sink, toilet, or shower, hiring a plumber typically costs between $110 and $350, with an average of around $200. Snaking a toilet or sink usually costs between $110 and $275, while a bathtub or shower clog costs about $225.

For a more serious clog in the main sewer line, the cost is higher. Clearing a main line clog generally costs between $200 and $600, with an average of about $380. However, prices can range from as low as $100 for snaking a minor clog to over $1,600, particularly if advanced methods like video inspection and hydrojetting are needed for a large or hard-to-reach blockage. Some severe main line clogs can cost upwards of $1,000 to clear depending on factors like the cause of the clog, its distance from an accessible cleanout, and whether the pipe is located beneath an occupied space (e.g., in an apartment building). You may be able to save money on minor clogs by using a drain snake or bladder yourself.

First, find the cleanout pipe in your yard. Unscrew the cap—you may need a wrench to do so. Then, get a drain snake. You can use a non-motorized one, but a motorized snake will make the job a little easier. Feed the snake through the pipe until it reaches the clog. Spin the snake continuously, but don’t try to feed it through the pipe anymore. Keep spinning until you feel it break the clog apart.

The best way to unclog a bathtub drain is to pour a pot of boiled water down the drain, being careful not to splash yourself. However, take precautions, as boiling water can damage PVC pipes and joints. Follow up with ½ cup of baking soda and ½ cup of vinegar. Cover the drain with a small sink plunger and let it sit for 15 minutes. Pour boiling water down the drain again and replace the drain stopper.