Top-rated structural engineers.

Get matched with top structural engineers in Falls City, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your structural engineering project in Falls City, TX?

Select your specific project to find the pro for you.

Verified Reviews for Structural Engineering pros in Falls City, TX

*The Angi rating for Structural Engineering companies in Falls City, TX is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Structural Engineering needs.

*The HomeAdvisor rating for Structural Engineering companies in Falls City, TX is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Structural Engineering needs.

Last update on October 09, 2025

Find Structural engineers in Falls City

Avatar for PJM Structural
PJM Structural
4.9(
28
)

Serving Falls City, TX and surrounding areas

Approved

In business since 2023

Free estimates

Emergency services offered

"Although I didn’t use their services, the promptness with a reply and the expertise displayed were exceptional. Whenever I need the services of a Structural Engineer, I will definitely reach out to PJM Structural."
New Restaurant Building
Pipe support frame
Truss webs and bottom chord damage
Interior Space
Pipe support frame

+15

Response time4 hrs
Response rate86%
Recommended by100%of homeowners
Request Quote
Avatar for GreenWorks Inspections & Engineering
GreenWorks Inspections & Engineering
4.8(
138
)

Serving Falls City, TX and surrounding areas

Approved

In business since 2009

Free estimates

Emergency services offered

"Exceptional professionalism. In-depth measurements. Critically valuable information. Patient responses to my questions and valuable insight from the engineering department."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+8

Response time1 day
Response rate95%
13 neighbors recently requested a quote
Request Quote
Avatar for The Basement Kings
The Basement Kings
4.8(
16
)

Serving Falls City, TX and surrounding areas

In business since 2004

Emergency services offered

Credit card accepted

"The Basement Kings finished their LARGE job this morning, and I can’t praise them enough! They had a long, difficult job, but no complaints. When they discovered a problem, they fixed it. No problem, that’s their job. They found the water problem had a lot to do with drainage, so they worked outside in cold & rain & developed a system to carry water away from the house. That, to me, was over & above, but they said their main objective was to get & keep the basement dry, so they did what they had to do with no complaints. Now you can’t ask for better than that - they give their all! I am totally amazed!!"
Recommended by92%of homeowners
Request Quote
Structural Engineering questions, answered by experts

Most lenders and homeowner’s insurance companies don’t mandate a structural engineer’s inspection, so in most cases, it’s not required. However, it’s a good idea to have one done anyway to ensure you know what you’re buying. You can use the report to carry out repairs after closing or even to negotiate the sale price before closing.

The 10 10 rule describes the formula most contractors use to determine how much to charge for a job. Allowing for 10% overhead above the total projected cost to do the work and 10% profit sets a contractor up for success, even if there are delays or other problems on the project. This formula isn’t a hard-and-fast rule, but it is a ballpark figure to begin with when estimating your expenses on a job.

Yes, a one-story house can have a load-bearing wall. The load-bearing walls in a single-story home are usually the exterior walls. If the house has a basement with exposed walls, the arrangement of the beams can help indicate what walls are load-bearing.

A 4-inch-thick concrete slab can support around 4,000 pounds per square foot if a contractor reinforces the slab with rebar, while that same slab without reinforcements will support closer to 1,000 pounds. For the purposes of a patio, 4 inches in thickness without reinforcement should suffice unless you’re installing heavy kitchen equipment or a hot tub on it. In those cases, reinforcing your slab and sticking with 4 inches of thickness should provide plenty of strength.

Generally, you can tell if a home is bolted to the foundation by checking the foundation for plates. If you see that your foundational plates connect to wood or bolts protruding from them, this means that you have a bolted foundation. However, it's always wise to bring a home inspector in to confirm if your foundation is secure.

The Falls City, TX homeowners’ guide to structural engineering services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"