Get matched with top dishwasher installation pros in Denton, TX

Dishwashers should be cleaned a minimum of once every 3 months, but really it should be done monthly. This is to prevent germ buildup and will help keep your machine running smoothly. Dishwasher maintenance isn’t too difficult, you’ll simply clean the filter, wipe down the spray arms with vinegar or rubbing alcohol, and run the cycle on empty. If there is any debris, you can remove it with a small metal pick. Do not use wood as the tip can break off inside the machine.

To clean an old dishwasher without a filter, start by removing the bottom rack to access the drain area. Use a damp cloth or sponge to wipe down the interior, paying special attention to the corners and crevices where food particles and debris can build up. Pour a cup of white vinegar into a dishwasher-safe bowl and place it on the top rack, then run a hot water cycle to help break down grease and grime. After the cycle, sprinkle a cup of baking soda across the bottom of the dishwasher and run a short hot water cycle to deodorize and further clean the interior. 

Your dishwasher drains through a hose that attaches to the plumbing below your sink or snakes out the back of your machine. In most cases, you can access one side of the hose from below your sink, as it usually ties into the same drainline that your sink uses. Otherwise, you may need to pull the dishwasher out of the counter to access it.

Yes, a dishwasher needs an air gap to prevent backflow. Additionally, in many locations, air gaps or another measure to prevent backflow are required for building code compliance. There are alternatives to an air gap, like a Studor vent or a loop and trap design, but an air gap is the simplest and most popular solution.