Get matched with top pressure washers in Cushing, TX

Sodium bicarbonate does not need to be cleaned up as thoroughly as many of its aggregate counterparts because it is not considered dangerous to the environment, nor to pets or people. While you will likely want to clean up the dust with a shop-vac and some water for aesthetic and comfort reasons, soda blasting cleanup is much simpler than for most sandblasting.

Yes, you must thoroughly clean your deck before staining. If you don't, dirt, debris, grease, and mildew can get trapped between the wood and the new stain. This not only looks unsightly but also prevents the stain from penetrating the wood properly, reducing its ability to protect the deck from weather and UV rays. As a result, the stain won't last as long or look as good. Any existing mold or mildew left untreated can continue to grow beneath the new stain, potentially leading to wood rot and structural damage. Always wait at least 48 hours after cleaning for the wood to dry completely before applying stain.

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.