Top-rated drywall insulation pros.

Get matched with top drywall insulation pros in Buffalo, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Buffalo, TX?

Select your specific project to find the pro for you.

Find Drywall insulation pros in Buffalo

Custom Insulators
5.0(
5
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Buffalo, TX and surrounding areas

Approved

In business since 2012

Free estimates

Customers say: Quick response

Custom Insulators, has been serving the Brazos County area since 2014. We specialize in spray foam, fiberglass, and blown in insulation. There is no project too big or too small. Call today for a free estimate.

Response time1 day
6 neighbors recently requested a quote
Recommended by100%of homeowners
BluSky NM Drywall Lath & Plaster Inc
4.8(
249
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Buffalo, TX and surrounding areas

In business since 1994

Free estimates

Emergency services offered

"The crew showed up every morning on time. They patched/drywalled and textured numerous small areas. The texturing was so good, that it is almost impossible to detect where the repairs where made. They also framed, drywalled and textured the kitchen area for recessed lighting installation. They repaired an area where there was a shower leak. They replaced the drywall and textured an area where a closet had been removed. On every part of the project, they exhibited superior workmanship. And at the end of every day, they cleaned up after themselves. Hire them again? Definitely yes! 
"
Additional Photos
Additional Photos
Additional Photos
Recommended by98%of homeowners
Avatar for SprayFoamTexas
SprayFoamTexas
5.0(
23
)
Blown-In Insulation - Install or Upgrade

Serving Buffalo, TX and surrounding areas

In business since 2022

Free estimates

Emergency services offered

"This company produced the quality of insulation they promised. We needed attic insulation as well as perimeter wall insulation. We asked for closed cell with open cell on top. The work was exactly as promised. Chester and his crew arrived on time and completed the entire project in one day. We are very pleased with the quality of the product, the work ethic of the men and the price of the insulation. We are very pleased with this company and would highly recommend them to anyone needing spray foam insulation."
Spray foam Closed Cell
Foam
Spray Foam Metal Shop
Foam
Foam

+2

Response time2 days
Response rate91%
Recommended by100%of homeowners
Edwards & Family Home Services
5.0(
5
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Buffalo, TX and surrounding areas

In business since 2019

Credit card accepted

Edwards & Family Home Services is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests, and make their concerns the basis of our business.

Response time9 hrs
Recommended by100%of homeowners
Avatar for The Air Guy LLC
The Air Guy LLC
5.0(
9
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Buffalo, TX and surrounding areas

In business since 2015

"Got 18” of well placed insulation added to my entire attic and a thorough checkup on my A/C’s performance. They improved my A/C’s return air flow which increased my system’s output by adding an additional return air duct. My cooling and heating bill was reduced approximately 30% as a result."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+83

Recommended by100%of homeowners
Avatar for ADT Solar
ADT Solar
4.4(
111
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Buffalo, TX and surrounding areas

In business since 2008

Free estimates

Warranties offered

"MARC JONES CONSTRUCTION TEAM  ARRIVED ON SCHEDULE AND INSTALLED THE SOLAR ARRAY OVER TWO DAYS.  ON MONDAY, WE HAD INSPECTION AND A FEW DAYS LATER THE ATTIC WAS INSULATED WITH FOAM TO REDUCE HEAT LOAD ON AIR CONDITIONING SYSTEM.  EVERYTHING WENT SMOOTHLY EXCEPT FOR INADVERTANTLY UNPLUGGING THE SYSTEM CIRCUITBREAKER DURING THE FOAMING OPERATIO.
"
11 kW PV Installation
5 kW PV Installation
9.5 kW PV Installation
Recommended by89%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Buffalo, TX and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Avatar for AIR NETWORK A/C & HEATING
AIR NETWORK A/C & HEATING
5.0(
10
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Buffalo, TX and surrounding areas

In business since 2003

Free estimates

Emergency services offered

"I received 3 quotes on installing a new 5 ton unit to our house air network was $2,000 cheaper than the # 2 bid and over $3000 cheaper than the other bid. They came when they said and chris was very knowledgeable. We had a new unit installed as well as all new ducting and blown in insulation. I would highly recommend air network in the Weimar area"
Recommended by100%of homeowners
Kogler Foam & Coating
5.0(
1
)
Injection Insulation - Install

Serving Buffalo, TX and surrounding areas

In business since 2014

Free estimates

Credit card accepted

We take great pride in our experience, expertise, quality and customer service that we provide to meet the consumers� needs. It is our mission to provide excellent workmanship and complete customer satisfaction from start to completion of a project. In order to understand the needs and expectations of our customers, we take great care to work and communicate with every customer in a professional manner. Our reputation is based on service, safety and quality, regardless of how large or small the job.

Response rate100%
Recommended by100%of homeowners
Avatar for Valor Flooring Consulting
Valor Flooring Consulting
4.4(
13
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Buffalo, TX and surrounding areas

In business since 1987

Free estimates

Emergency services offered

Valor Flooring Consulting prides itself as well as the business on all the core things the military has taught (i.e. Loyalty, Integrity, and honesty).\n\nGulf Coast Flooring specializes in hard surfaces, such as Vinyl Plank, Laminate, wood, and ceramic. There isn't a flooring job I cant handle. Gulf Coast Flooring will come to your home free of charge to give you and your family a quote as well as bring flooring samples. \n\nGulf Coast Flooring offers work at labor only prices that are VERY hard to beat. While our prices are low the quality NEVER is. Our belief is that those who have worked hard to earn their money should be able to get the floors they want and not break the bank.

From Carpet to Vinyl Floors
Kitchen/Bathroom Remodel
Entire Home Installation
No Floors to Floors
Hardwood Flooring Sales and Installation Project

+60

Recommended by91%of homeowners
Showing 1-10 of 19
Drywall Insulation questions, answered by experts

Very little. One inch of water can stain walls, warp wood, and create a perfect environment for mold growth. One to two inches of water can do significant damage to drywall, insulation, and electrical systems. Anything over that is considered an extensive flood, often resulting in severe structural damage.

While fumigation chemicals cannot pass through solid objects, they will seep into any openings in walls, doors, or other closed spaces. This allows them to get into tight places where pests may be hiding and causing damage, like termites ruining the foundation of your home. It also means that your home needs to ventilate for 48 hours before returning to ensure that no harmful chemicals remain in your space. 

Yes, taping inside corners is a critical step in the drywall installation process.  Properly taping inside corners is essential for achieving a professional look, and an installation that resists cracking and maintains its integrity over time. Taping the corners involves the application of a joint compound along the seam where two drywall pieces meet. This process provides reinforcement, conceals the seam, and prevents future gaps or cracks from developing.

The age of your home can clue you in to whether you have plaster or drywall ceilings. Homes built after the ‘70s are more likely to have drywall ceilings and walls, while older homes have plaster. You can also do the pushpin test: A pushpin will go into drywall, whereas it’s much harder to push one into a plaster wall. If you’re still unsure, ask a drywall professional to let you know which type of ceilings and walls you have.

If you’re installing new drywall, you may need to skim coat the drywall first for a smooth finish and to allow the primer to adhere to the wall. It’s only necessary if there are imperfections in your drywall due to issues with the studs or improper drywall installation. If you’re refreshing existing walls, you may want to skim coat if there are imperfections across the wall. As an alternative, you can repair your drywall and sand it for a smooth finish before painting.

The Buffalo, TX homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.