Get matched with top roofers in Lancing, TN

EPDM roofs have a few common problems, most of which can be resolved with regular maintenance. This type of roofing is laid down in sheets with seams, which can be a starting point for leaks. Proper installation and roof sealing can often avoid seam issues. 

The material is also susceptible to tears and punctures from falling branches or other sharp objects. There are black and white versions of EPDM, and the black version is more prone to fade and succumb to UV damage. Regular roof inspections can protect the costs of rubber roof installation and extend the life of your roof.

The common formula for measuring a roof is length x width equals square footage. Professional roofers measure the length and width of your roof, including dormers, and determine its pitch and rafter sizes. If a roof surface is a triangle, they’ll divide that square footage by two, then add up the square footage of each surface to get the total for the roof.

There should be small gaps between your roof and the walls of your home, and other buildings. These small gaps let building materials shift, expand, and contract with weather and other outside forces, and they prevent moisture from wicking down walls from roofing and gutter systems. Without these strategic gaps, your home’s exterior and its finishes can sustain water damage, decay, peel, delaminate, and crack. However, there is a fine line between a smart gap and a problematic gap—all  gaps should be small, intentional, and covered or filled in with foam insulation to prevent pests from using them as access points.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.