Get matched with top water heater pros in Webster, SD

You should replace your gas water heater when it’s reached the end of its lifespan, which is a maximum of 12 years in most cases. If your unit is over a decade old and showing signs of inefficiency, leaks, or frequent malfunctions, it may be time to replace your water heater. Research how to best maintain your gas water heater to help extend its lifespan.

Yes, most municipalities have codes that require water heaters to have pans. A pan is necessary when a water heater or hot water storage tank is installed in an area where water leakage could cause damage, such as an attic, second floor, or finished basement. Tankless water heaters are not required to have a pan since there is no storage tank.

Most standard residential water heaters, which are typically around 40 gallons and use 240 volts and between 3,500 and 5,500 watts, require a 30-amp, two-pole circuit breaker. For smaller, point-of-use water heaters using 120 volts and between 1,500 and 3,000 watts, a 30-amp breaker is also often adequate. However, some models may have different needs; units that use more watts than average may require a 40-amp breaker, while smaller units might only need a 20-amp breaker. Newer, tankless, or more energy-efficient models can also require a higher amperage. Having the correct breaker size is crucial for safe and efficient operation, so it's best to consult a licensed electrician to determine the specific needs of your water heater.

Yes, a heat pump water heater can work in colder climates but it’s much more effective where it’s warm. The reason is that the heat pump needs ambient warmth in the air to compress. The less warmth, the more compression required, thus using more electricity and offsetting the energy-efficient benefits.