Top-rated water softener pros.

Get matched with top water softener pros in Spearfish, SD

Enter your zip and get matched with up to 5 pros

Need a pro for your water softener service project in Spearfish, SD?

Select your specific project to find the pro for you.

Find Water softener pros in Spearfish

Patriot Plumbing Inc - Home Facebook
4.5(
87
)
Well Pump - Repair or Service

Serving Spearfish, SD and surrounding areas

In business since 1985

Free estimates

Offers commercial services

"Patriot Plumbing arrived promptly, diagnosed the problem, provided a verbal estimate and began work all on the same day. They replaced the bath fixtures in the upstairs bathroom and a pipe that was leaking. Travis also installed a water heater overflow tank. They stuck to their estimate and completed the work in a timely manner, but did leave us with open holes in the drywall to dry out the water damage and later silicone the hatches in ourselves. The hole for the new access hatch was cut a bit too big, so we'll have to patch that with spackle ourselves."
Response time1 day
Recommended by97%of homeowners
5th Generation Plumbing
New to Angi
Well Pump - Repair or Service

Serving Spearfish, SD and surrounding areas

In business since 1997

Free estimates

Credit card accepted

We are a locally owned and operated company that values honesty and integrity in all aspects of our business. Our major focus is on the quality our work and producing outstanding results. We are committed to creating a level of value unmatched by any of our competitors. We look forward to building lasting relationships with our clients and guarantee your satisfaction!

Water Softeners questions, answered by experts

The average cost to install a water softener, including the system and labor, is approximately $1,500. However, the total price can range widely from $600 to $6,000. For some complete systems, the cost may be between $800 and $2,500. Labor for the installation typically costs between $150 and $1,000.

The final price is influenced by several factors, including:

  • System type, capacity, and complexity

  • Home size and household water demands

  • Water hardness levels

  • Accessibility of the installation site and the extent of plumbing work required

  • Whether new electrical work is needed

  • The professional hired and any local permit costs

Softener systems extend appliance life spans, improve skin and hair health, and reduce pipe buildup by removing minerals like calcium and magnesium.

It’s not a good idea to oversize your water softener. Doing so will mean the tank doesn’t get full, which can lead to channeling. This leads to a large portion of the resin beads not being utilized and the beads at the bottom of the tank being overused. Over time, this will reduce the efficiency of your system, not to mention that the upfront cost of an oversized softener is unnecessarily high. If you have a timed regeneration cycle rather than a demand-based one, you’ll also spend far more on replacing salt than you need to.

You can install a water softener system by turning off the water supply, draining the water, and then connecting your device to the waterline. Next, you’ll fill your tank with the recommended amount of salt or brine (whichever your unit calls for; be sure to read the instructions). Turn the water supply on and check for leaks. You can opt to let your water run for a few minutes, then test it using strips. 

The process of inspecting your water softener system is similar.

While it depends on how complicated the unit and installation is, it takes two to four hours to install a water softener unit, on average. It might take longer if pipes need to be replaced. You should make sure the installation area is clear of any objects that might get in the way before you begin.

The Spearfish, SD homeowners’ guide to water softener services

From average costs to expert advice, get all the answers you need to get your job done.