Top-rated drain pipe installers.

Get matched with top drain pipe installers in Porcupine, SD

Enter your ZIP and get matched with up to 5 pros

Need a pro for your drain pipe installation project in Porcupine, SD?

Select your specific project to find the pro for you.

Find Drain pipe installers in Porcupine

Maintenance Man Construction

30855 445th Ave
No reviews yet

Maintenance Man Construction

30855 445th Ave
No reviews yet
15 years of experience

We are a small construction company of 3 to 4 guys who specialize in getting your project done with a personal touch! Unlike your typical contractor we will fully dedicate our time to your job and see your project out from start to finish.

We are a small construction company of 3 to 4 guys who specialize in getting your project done with a personal touch! Unlike your typical contractor we will fully dedicate our time to your job and see your project out from start to finish.



"Guys were on time, friendly and worked quickly. They installed a new kitchen faucet and a soap dispenser. For sure would hire them again."

Steve L on September 2018

Additional email - [email protected]

"Guys were on time, friendly and worked quickly. They installed a new kitchen faucet and a soap dispenser. For sure would hire them again."

Steve L on September 2018

Drain Pipe Installation questions, answered by experts

While there is no specific “best” method to clear hair out of a drain, several options work well. Using a combination of baking soda and vinegar to dissolve the hair clog is a great and easy way to help clear the drain. Drain snakes are also effective for more severe clog buildups. 

On average, a plumber will take 30 minutes to two hours to clear a clogged drain. If the clog is located close to the drain or an access point and isn’t severe, the project will take about half an hour. If the clog is deep within your plumbing system or is a severe blockage, it can take two or more hours to remove the clog. For this reason, main line clogs tend to take longer, usually between two and three hours.

According to the U.S. Environmental Protection Agency (EPA), a leaky faucet that’s dripping at a rate of one drip per second can waste more than 3,000 gallons of water per year. This is one reason why it’s important to fix a leaky faucet sooner rather than later.

No, shower valves and cartridges are not universal. When researching the type of shower valve you need, make sure you get the model number of the old valve or cartridge and match it to the new one. Otherwise, it might not fit. To find the model number, check to see if the old part has a brand or serial number stamped on it. If you can’t find that number, contact the manufacturer or check their website to see which valves and cartridges fit together.

No. You should never directly drain a water softener into a sewer cleanout. This practice is illegal in many areas because it could allow raw sewage to get into your drinking water and make you seriously ill. Many places have codes requiring a specific seal, pipe, and a large air gap between a water softener and a sewage cleanout. Check out Florida's Plumbing Building Code as an example of what these restrictions might look like.

The Porcupine, SD homeowners’ guide to drain pipe installations

From average costs to expert advice, get all the answers you need to get your job done.