Top-rated drain pipe installers.

Get matched with top drain pipe installers in Allen, SD

Enter your ZIP and get matched with up to 5 pros

Need a pro for your drain pipe installation project in Allen, SD?

Select your specific project to find the pro for you.

Verified Reviews for Drain Pipe Installation pros in Allen, SD

*The Angi rating for Drain Pipe Installation companies in Allen, SD is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Drain Pipe Installation needs.

*The HomeAdvisor rating for Drain Pipe Installation companies in Allen, SD is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Drain Pipe Installation needs.

Last update on October 29, 2025

Find Drain pipe installers in Allen

AAA Plumbing

1401 Oregon St
4.69(
39
)

AAA Plumbing

1401 Oregon St
4.69(
39
)
Customers say: Quick response
36 years of experience

Additional email - [email protected]

"Guys were on time, friendly and worked quickly. They installed a new kitchen faucet and a soap dispenser. For sure would hire them again."

Steve L on September 2018

Additional email - [email protected]

"Guys were on time, friendly and worked quickly. They installed a new kitchen faucet and a soap dispenser. For sure would hire them again."

Steve L on September 2018

Drain Pipe Installation questions, answered by experts

Pipes tend to burst once frozen for 24 to 72 hours. It takes temperatures 20 degrees Fahrenheit or colder for several days to freeze and burst pipes, rather than a day or two with temperatures hovering around freezing. When temperatures are dropping, it’s time to drip faucets and open cupboard doors that house pipes to circulate heated air.

You can buy a sealant spray for a leaking copper pipe, but it’s not a permanent solution and isn’t usually a good idea. For the best adhesion, you should drain the pipe, let it dry completely, apply the spray, and wait for it to dry before turning the water back on. Even with proper technique, a sealant spray is a temporary fix, so you should only use this technique in the interim to prevent water damage if you’re waiting for a more permanent fix.

Plumbers use a variety of tools to help unclog the toughest of drain clogs, but the most common tools they use are drain snakes and augers. They try a plunger or drain snake to start, then move to heavy-duty augers, and finally try using a hydro jetter to blast away the clog with high-pressure water. Hiring a plumber to unclog a drain costs $125 to $300, largely depending on the extent and location of the clog and which of these methods is best for clearing it.

It is okay to use a drain auger on a toilet, just make sure you are using the correct tip size. The auger is a plumbing snake with a protective sleeve to protect the porcelain toilet bowl from getting scratched. Using too large of an auger can cause the snake to loop back and damage the inside of the drain and plumbing.

For easy-to-access pipes, your plumber will shut off the main water line and replace the pipes without demolishing your property. Underground or difficult-to-access pipes require different approaches. There are two ways to replace underground cast iron pipes: trench and trenchless sewer line replacements. Trenchless replacements result in minimal damage to your yard and involve bursting pipes and replacing them with new ones via an access point.

The Allen, SD homeowners’ guide to drain pipe installations

From average costs to expert advice, get all the answers you need to get your job done.

See all articles